5.5 tonne hitachi digger.
Looking for a bit of help...
Lift and dipper arm crowd have gone really slow, and will then jerk and start moving properly. Everything else is working fine and seems to still have plenty of power although I didn't have anywhere to test it very well.
So I'm taking on some land in the spring and having walked it a few times some of the ground is suffering with surface compaction.
Obviously I could just run a grassland subsoiler through it but I'd rather not if possible. What are my other options?
I have a small portable milking machine that I use for milking my few goats and trying to figure out how to setup a sensible wash through system instead of doing it by hand every day.
Got a water heater but I'm struggling to work out how to set it up so it circulates through the bucket
Got a ewe with 2 week old twins on her and they've chewed her teats because sheep are fudgeing idiots. she's been feeding one fine but the other one is obviously not getting enough milk.
Naturally the little one won't suck off a bottle
Bit stumped for ideas short of taking them both off until...
My turnout paddock is looking a bit worse for wear this year, probably not helped by digging half of it up to out a shed on, but anyway.
Wants a reseed to clean it up and I'm pondering the idea of putting in something like plantain or chicory or a mix that can be grazed straight after lambing...
fudgeing livid with myself, split a zetor 3011 to replace a gear putting it back together and broke a piece of the bell housing off on the flywheel side.
Anyone know any good welders in Somerset who would weld it in situ?
Or what are my other options?
On an unrelated note I could do with a...
Hitachi ex55ur here with a dodgy starter motor, sometimes fires up fine, sometimes it kicks in and then whirrs and sometimes nothing happens at all for a while and it will either start or not start.
I assume it's a dodgy starter but finding any sort of replacement is proving difficult...
I know there's been a few threads on this but looking to modify our existing system and put a race etc. In
What size holding pens do people have. What works best? Can go up to about 15 foot wide and the shed (currently cubicles) is roughly 40 ft long though I might not use all of it
Just picked up a dead ewe and not sure what to do with her lambs!
3 weeks old would you let them fend for themselves, bring them in and try and persuade them that milk from a bottle is a good idea, sell them?
To cut a long story short I've been borrowing a digger that the guy now wants to sell.
It's a Kubota kh101
The tracks/sprockets/rollers are shot and need replacing. Engine has a small diesel leak on one of the fuel lines but other than that runs fine. Needs a fair few ram seals replacing as well...
Advertising for a friend. Two Welsh collies free to a good home. Need rehoming due to a change in circumstances as far as i know. Bitch and a dog both under two years old. From working parents as far as I know but bought as pets so never been trained.
Need to go to somewhere they can work or at...