Does anyone here use Flex Fertiliser. I’ve a Chafer sprayer with a Hypro pump on it and I was wondering if it’s suitable to use with the Flex fertiliser. And if not what pump would be
Speed is reading the same on the rate controller as gps but the pressure is going up and down a lot was. Was driving at 10km and pressure was jumping from 1.7 bar to 2.5 bar
We’ve a new to us 2010 418 and can’t get it to spray the right volume. Have it set at 160l/ha on the TeeJet rate controller but only once has it put out the right volume. Has anyone any ideas what could be causing this
You can check the bearing if you’ve an inspection camera. In through the fill point. Takes a bit of practice but after a few goes it’s fairly straight forward
The problem being that anytime from the bale being 80% made the baler clutch can go off. This is in light rows. The accumulator I know about but from what I’m told it’s a short term fix
We sowed some annual tetraploid ryegrass last September and cut it at the end of October . It was fertilised in January and we mowed it today and will be baled tomorrow. Is it worth fertilising again or will it not produce enough to justify the cost
It’s all about the operator. 3-4 miles is about where their advantage starts to run out but shorter than that and they’re excellent. I know of lads moving 12000 bales a year with them
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.