Have a 2009 JCB 526-56 that seems to be stuck in 4wheel drive constantly. Worked fine up until a couple of weeks ago.
The little orange light on the switch on the dash doesnt light up anymore - I think it used to light up when it was in 2 wheel drive? If you had it in 2 wheel drive, the 4wd...
Have a 4 way ball valve on our knight sprayer that isn’t working right.
It should divert between spraying, recirculation through induction hopper, and the tank cleaning spray heads.
The motor is turning the shaft when you change between functions but it must have lost its position as it’s not...
Our newly arrived 2140 has spent most of its life with a demount sprayer fitted, so the linkage components are mostly seized up. I’m looking at getting a pair of new stabilisers, but the JCB ones don’t seem to be a great design. You can turn the adjuster which pushes the arms in towards the...
Fastrac and demount sprayer, set of spare row crop wheels and box of spare parts required from Caernarfon, wales up to Keith, moray. No hurry. Fastrac and sprayer is 13 feet high so probably low loader job?
Wanted - set of 12.4 R46 & 12.4 R32 or similar for valtra tractor.
Preferably 8 stud with a 220mm centre hole but could adapt if required.
Also second pair of 12.4 R46 with same stud pattern to fit trailed sprayer.
Scotland preferably
We’ve just bought a second hand 12 tonne pedrotti/masters dryer, diesel fired/PTO drive. We do have an old 80hp case that would be fit to drive it, but for various reasons I’d rather not have it tied up on the drier.
I have a 120hp 6 cylinder Perkins engine here from a Massey 625 combine and am...
I spent Christmas up at my OH's parents in Shetland, and one of the jobs when I was up there was to have a look at their Benford 9 Ton dumper as it was clattering, filling the exhaust with blue smoke and generally burning more oil than diesel. Sump off revealed a big end bearing had...
I’m in the middle of giving our old set of Dalbo Cambridge rollers some long overdue TLC. The shafts run in nylon bearings which are just about worn completely through, but the new replacements I've been sent are seriously slack on the shafts.
I wondered if anyone on here had seen anything...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.