Search results

The refund all agreed by then was for the cost of having to rectify problems on the machine, not returning the machine.

Anybody else had any issues with Coles, bought a fully serviced ready to go combine from them that turned out not to beready. They agreed to refund a chunk of the cost to bring the combine up to being ready, this seemed fair but they aren’t coming up with the money. Not dealt before but...

Brilliant thanks I’ll ring a couple on Monday

Just looking for recommendations for a haulier to move a tractor from Builth wells to Newcastle. Thanks

A 6155m with a little tune up, new or Ex HS2 if not I’d probably say something Cnh with as lower starting price as possible

I have always believed the NFU to be a lacklustre and poor excuse for a union but unfortunately it is all we have, however I’m starting to wonder if every pound we put into the union is not only wasted as previously thought but actually used against us. On the ground to county level there are...

This as mentioned is to be expected of Red Tractor, after all they are essentially managed by the supermarkets to gain something and the farmer having to pay for it. The NFU allowing this to happen silently whilst on the board is disgraceful. I think there stance on this has left us all...

I don’t see why anyone who sells stores would ever be red tractor there are no benefits

What would you expect of a 1500hr service cost on a compact telehandler by main dealer in warranty. We provided engine oil and where charged over £1,600 plus vat which included £800 labour. Only a small 2.5t handler 75hp

By better do you mean more in them? Or just faster/tidier Interesting to say your getting more in with the roller baler we average around 700-750kg with silage and every extra saves quite a few bales over 2000

Yeh we can easily get 75mm right round on the top one, plus all wedged in where the bale sensors are that takes a lot of cleaning off. The others normally 10mm which is quick to clean. The belts completely green with bits stuck on. Which baler do you run?

Is it not possible to ease the pressure off on a roller baler? I’ve only ever used a belt. Are you getting as much in with the roller Kuhn and the belt baler? Unfortunately local Krone dealer backup is terrible

Thanks everything is chopped and sometimes we can’t get more than 100-150 bales before the belts stop spinning. Its packs in under the scraper and rod with the bale size sensors on and can easily take an hour to clean off that and the other rollers.

Currently running a Kuhn VB3165 round baler, is a great piece of kit apart from wrapping grass around all the rollers when bailing short, lush grass with lots of clover. This type of crop is now the majority of our silage, would any other roller balers be better at this? I’m guessing a...

There is a hole yes

I’m pretty sure that’s what I need

Where would I find a drawbar for a Massey 698T at a reasonable price?

We pull a manual vari-width 4f auto reset Kv plough with either a mf5713 or a 4cyl jd6140m. Breeze for the jd is a bit heavy on a steep headland for the mf but flatter land is no problem.

15k 😳

A few more questions Will we fit 12 fat cattle in 26’ average 630kg or do we need to got to 28’ The Stewart trailer is very expensive would it match with a Marshall trailer? We have a Marshall 26’ bale trailer would this be ok for a while, it is unfortunately on super singles is this too...