Hi
Just wondering would anybody know the correct hydraulic pressure at the sensor on the front of the power quad transmission
It suddenly started illuminating the dash light from cold so I took it off and put a gauge on which recorded 160 psi at idle and didn’t alter at higher revs
Hoping...
Have a 4wd 2850 with loader that I’m using for heavy round bale silage
Had heard that the front axle was a bit weak on them for constant heavy loader work
Is there any preventative maintenance work you cold do on them or any early signs that there might be a problem occurring
I have a a 3050 which has stiff steering when cold but is reasonable when warmed up
It has the correct spec oil
Screen is clean and filters changed
It will tip a twin ram trailer without juddering at tickover but I need to be 1800 revs to run a wrapper at sufficient speed
I tested port on...
Hi I have a jd 3050 with a tired main pump, when I put a gauge on one of the spools it makes 2600 psi but flickers by about 300 psi , also the steering is very stiff when cold but ok when it warms . I was told that some of the pistons in the pump are prob sticking and that its probably as cheap...
Hello there, our Mf 4270 24/24 power shuttle is popping up a hydraulic clutch warning light ( cog with a line thru it) after about 1/2 an hour driving flat out . No other codes etc coming up . It is still driving perfectly . Have changed various switches and sensors and swapped solenoids from...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.