Search results

  1. L

    New Holland pickup hitch won’t release..

    Let down the lift slightly while pulling the lever, lift could be gone out of calibration.
  2. L

    Aircon high pressure switch

    Anybody know if you can change one of the above on a new holland tx63 combine without draining gas? Thank you
  3. L

    Case multicontroller

    No major mechanical issues. Just annoying things blew o rings twice at the top of pump, front suspension readjusting heigh at low speeds, not sure if that's connected to o rings above. Suspension dropping to the stops at night (waiting for lockout valve replacement to see if it cures that) error...
  4. L

    Case multicontroller

    I purchased a mf 6613 dyna 6 in 2016, a lovely reliable tractor. Had the usual soft drive issue but only servicing cost after that. In 2020 I went to upgrade, priced mf nh and case. Massey dealer absolutely no interest (a new dealer opened up closer to me since, which I didn't know about at the...
  5. L

    Welger 235 repair

    Does anybody know the tightening sequence and torques for the taper lock sprockets. Thanks
  6. L

    Case puma x

    Where i work has a t7165s, the trumpets are lighter that a t7210. The rest is similar to a classic. Some things are a little stingy, i think the passenger seat, rear wiper and fender extension were extra. Also back to tying the spool with a twine for constant pumping. No power boost either which...
  7. L

    Tractor replacement

    I changed from a 4 pot 110 hp case with boost to 130 to a massey 66 series in early 2016. I was like you set on a 5613 with loader, tried one and taught it a damn fine loader tractor but not any handier around the yard than the case even though it looked smaller. When I mentioned a vari-width...
  8. L

    New holland Tm error codes

    Looking at a tm 130 at the weekend, it had some error codes on the dash eec 2 and eec 4 on the dash and f 20 on the gear display anybody have any info on them thanks
  9. L

    Case multicontroller

    I know you can't compare cvx to dyna 6 but case don't offer anything to compete with dyna 6. After driving a new 16/16 case maxxum it confirmed all my fears, my god they have made them noisy . Dyna 4 and dyna 6 miles ahead for smoothness and user friendliness . I do prefer the case compact...
  10. L

    Case multicontroller

    Just to update this. Have it narrowed to these case cvx 130 and mf 6613 dyna 6 . A case 120 multi controller is still in the running but that question will be answered with a demo. Mf is a bit cheaper than cvx, not sure of the multi controller yet but if its anywhere near the price of the mf it...
  11. L

    Case multicontroller

    Oh deere could you pm me details of that 130 cvx thanks
  12. L

    Case multicontroller

    So looks like they have stretched the wheelbase by 200 mm which brings it close to the wheelbase of the current 66 range of Massey Ferguson's which are only 30mm shorter than a 6260 dynashift I had. Gearboxes the same only looks like dual power is gone probably not able for the power and...
  13. L

    Case multicontroller

    They are a fine tractor but a bit too long for me. I do a lot of yard work with the loader and follow a fusion in the summer drawing in the bales and also row in front of it . 130 hp is plenty and four cylinder is best suited for my needs. I'll get the dealer to have a look at what is in stock
  14. L

    Case multicontroller

    Ali how many hours is on the 110 with two spools nearly gone? I suppose we all look at how much the electric spool is at around 1000 but the price of a mechanical spool might surprise might also frighten you. My 110 is 06 and the whine is not to bad only in higher reverse gears. Its the new ones...
  15. L

    Case multicontroller

    Farmall is far too light for a 4m loader and short on power. Is it a steyr based gearbox in them. Nelson have you had problems with the 16*16 gearbox or just not happy with how noisy they are? Looked up the McCormick tractors and quite surprised fpt engine and zf all the way back, x7 is...
  16. L

    Case multicontroller

    Dealers would be the problem with either McCormick or landini . Further away and only selling small numbers so backup and know how might not be the best. All the ones I priced are within 20 km. Victor was Deutz 1800 for replacement electric spool ??? :scratchhead: that's crazy money sterling...
  17. L

    Case multicontroller

    Looks like I can put manual spools on maxxum cvx but not on multi controller. The loader joystick would still be electric, ill have to chat to the dealer about it, it wouldn't be the first time brochures were wrong. Dual power option welcome back the eighties, I wouldn't mind a gearstick but you...
  18. L

    Case multicontroller

    Cvx brings the multi controller as standard. All spools are electric with them too unlike mf where you can have two electric and two manual. Puma don't seem to have a option of manual spools is that correct? I suppose it boils down to how reliable they are, tractor stays around here a good...
  19. L

    Case multicontroller

    Place I work sometimes has a t 6.150 so I know what they are like. Case is identical to the one I have apart from adblue ( they somehow have made the cnh 16 speed gearbox whine even more in the new ones, the main reason I'm looking elsewhere ) I will try get the 6613 on demo because they are...
  20. L

    Case multicontroller

    They are only giving cost to change at the minute probably leaving some room to wiggle on their paper quotes. But the mf man quoted me on a 6614 first I nearly fell over 22k more than the case to change. So came back with a price for a 6613 which is 15k , deutz 12k , new Holland 5k more than...
Top