Search results

Thanks again gapples, that's brilliant, I'll try and find someone to do it. Done a lot of work on the T20 fergusons, engine rebuild etc but this looks more daunting and with age doesn't get any easier. Thank you for your excellent input.

Thanks gapples . Does timing need to be locked. Think I need to call someone in to do this

Hello all I've a diesel leak on pump on 895. It seems to be coming from where the throttle linkage enters pump. Is this a job I can do myself? I assume pump will need removed and will that upset timing ?

Hi Anyone know a good on site mechanic in co down. Need work done to a case international 995

Thanks everyone for the info

Thanks guys. Will give him a ring

Does anyone know where I can buy these hydraulic lever link arms or will it be a breakers yard. There adjustable too.

Thanks all. Your definitely right melted welly. Pictures are exactly right. You learn something new everyday. That manure is 3 yr old and been lying outside

They did see a few frosts but no blackness. Could be chemical

Put in a small plot each year but this year half the leaves are curled but other half is normal. I'd put manure on the ground where the leaf curling has taken place but not where there normal. Could it be frost? The odd one is fine among the curled ones

Anyone got a 10x 5 scrap hi-line car trailer lying about. Think they were made in Derby

Thanks everyone. I think the 895 lift rams are unique to that series. Cx is too wide and as u say gerard room is limited as to where they fit

Gerard I'm in co down. Would love to know if cx ones fit 895

Hello gerard. I'm in n. Ireland. I would doubt they'll fit if there slightly wider as it's a pretty tight fitting. Will take a photo later.

Thanks ex farmer. I lift potatoe boxes full of logs with a ripvator forklift. Cam manage ok as it is but I thought that maybe there should have been 2 on it

That's it folks. See a sheared bolt at the bottom of the missing one so I'm assuming it had one on it

Anyone know where I get a rear lifting ram for my 895. Theres two on them but I'm missing one. Is there a left or right hand side or both the same? Thanks in advance

Has anyone got one of these loaders. Looking dimensions for the brackets that are used for removing loader or if anyone has brackets for it that I can purchase. Thanks

Tyres are 16.9r34. I havent changed them and about 50% worn. Here's the forklift attached. I could take wheels of forklift.

Hello all. Some implements are catching the rear wheels so I need to extend the rear arms. I can lift a lever and extend the rear arms but it's very flimsy. I'm I missing something here or is there another way round it. Any advice greatly appreciated