Search results

We have one here that hasn’t been used for a good number of years. Don’t know what make it is

6400 but not from the leaping deer stable, A Valmet 6400 would run rings round the JD.

Hi, I've sent you a private message regarding grazing

Thanks for that Brisel, I put kerb on 7 days ago. Was told I could put the Fox and oil on at the same time but I didn’t fancy doing that.

Back in September the feeling was that if we waited for the right timing to use Astrokerb the mayweed would of been to big and that definitely would of been the case with how mild it’s been, Agronomist has always said that you can’t rely on Astrokerb to kill mayweed. Charlock hasn’t been in...

Decided to leave it for the time being, was -5 last night so hopefully that will maybe kill it off? There’s still 3 months of winter to go and we do normally get a few cold sum minus temps so will monitor and apply if necessary. I have got oil to go with the Fox. It did receive 0.25l Belkar back...

Got a block of OSR that unfortunately has charlock in it which came in the seed:(. I’ve got some Fox to put on to take it out which I was planning on putting on tomorrow as due to be. -4 tonight, then -3 tomorrow night. Just wondering though how cold it needs to get down to for frosts to kill it...

Probably no use to you but we have some 4’ x 16” x 3.5” concrete pig slats.

The older style Massey 45kg weights will fit your tractor if you just grind a little bit off the bottom lug, doesn’t need much.

Get 6 nozzles that you don’t use/worn out ant put some superglue over the inlet hole to the nozzle

Anybody had any recent prices for MOP and TSP?, Yorkshire area

Another 9mm yesterday, Now at 48mm for August adding to the 127mm we had in July. Harvest well and truly on hold

As title and need to be 8 stud

I’ve noticed the same in our spring beans (lynx)

Are 18volt batter powered leaf blowers any good for corn store floors?, Do they have enough puff or am I better off getting a Stihl engined one. It would be a Dewalt battery one if I was to go down that route.

Sold a load of wheat this afternoon for £197 July movement as need a bit of cash as haven’t sold any wheat since Nov last year. Hopefully the market will keep rising.

Think Richard Bell machinery bought the £4000 trffitt trailer

Running a Claas Dominator 108VX combine and looking into overhauling the drum and concave. Rasp bars are worn out on drum, Concave is in straight order and would maybe do a couple more seasons but ideally want to change the lot. Quite fancy the Hardox steel concave made by “combine...

We had a 2D buggy on a D reg for about 12 years. Had a 1000 litre Hardi sprayer on with 18 metre booms. On the whole it was a good machine and very handy to just jump on and go. Definently helps if your handy with the spanner’s as they need looking after!. Ours used to go through a clutch cable...

Cut the beans today, Opted for the standard header. Was planning on spraying them off about 10 days ago but didn’t get round to it, Went quite well although had to use the reel a bit more than I would of liked as was bunching on the table now and again. Had a good lick on with a fast reel speed...