Search results

  1. 8

    International Harvester 885xl 4x4 yr 1982

    Well spool problem sorted now,spoke to a agriculture technician bout all this,holding pressure in left hand quick release,he said even though you have replaced both LH and RH quick release couplings,the pipe that joins LH quick release coupling undo it then follow pipe back to the other end undo...
  2. 8

    International Harvester 885xl 4x4 yr 1982

    Hi,this is the problem,pressure is staying in the left hand coupling,tractor turned off,in cab spool lever pulled up and down a few times,to release pressure,pull out the right hand quick release,that’s good,push it back in again great done,obviously still no pressure in spools,go to the left...
  3. 8

    International Harvester 885xl 4x4 yr 1982

    Hi,I’ve tried your experiment,started tractor up,No Hydraulic pipes plugged in,pulled up spool lever in cab,pressure on,tractor labouring,pushed spool lever fully down,pressure on,tractor labouring,left lever in middle tractor running ok.If i had air in the Hydraulic system how would I get air...
  4. 8

    International Harvester 885xl 4x4 yr 1982

    Thank you for looking in,ok I will try your experiment later tomorrow,thankyou,used a trailer, yes but remembering placing trailer pipe in the right hand quick release coupling,,so obviously lever in cab fully up(fully down pressure left hand quick release coupling) but remember pushing lever...
  5. 8

    International Harvester 885xl 4x4 yr 1982

    Hi,I’ll check which pipe it is tomorrow,with tractor turned off ,wiggle lever in cab up and down,still has pressure,after a couple of hrs,it will allow me to insert Hydraulic pipe leaving tractor turned off.you mentioned back pressure that’s what I’m thinking ,,but how.would it be because I’ve...
  6. 8

    International Harvester 885xl 4x4 yr 1982

    Hi,the tee has always been there,nothing to do with main problems,I have one spool in cab,I can plug in hedge trimmer in the right hand quick release with the spool lever in the up position locked,and trimmers return plug in the return quick release which is in centre of the two LH and RH quick...
  7. 8

    International Harvester 885xl 4x4 yr 1982

    Good evening to you all,thankyou for replying to my problems,I’ve taken two photos,one showing 2 x yellow arrows pointing out 2x New quick release couplings,and the other picture showing the two feed pipes feeding the quick release couplings,but the nut,,blue arrow,,is this like a relief...
  8. 8

    International Harvester 885xl 4x4 yr 1982

    Hi thankyou for looking in,I’ll take pictures tomorrow of the rear of tractor tomorrow after work.
  9. 8

    International Harvester 885xl 4x4 yr 1982

    Hi all,looking for some guidance on the two quick release spools on rear of my tractor,when spool lever inside cab is operated to open and shut a door on a topper,the quick release spool on left had side just holds oil pressure,even if the lever in cab with tractor turned off,is lifted up and...
  10. 8

    Fan switch

    Hi all,I’m looking for a fan switch for my International 885xl 1982,the one inside cab ,,1,2,3 speeds.
  11. 8

    Isuzu d max double cab

    Hi,I have on 13 plate Yukon double cab.square tube one,very handy.
  12. 8

    International harvester technician

    Sorry ment to say,no position lever only works enough to release pickup hitch other than that it has no resistance.
  13. 8

    International harvester technician

    Yes we’ll Mur, been with it all afternoon; thinking it’s something to do with the draft settings,I’ve set the rod to 84mm between eyes,but had enough of climbing in and around tractor,I’ve put hedge trimmer on now so will have another go when I’ve finished hedge trimming,with hedge trimmer and...
  14. 8

    International harvester technician

    Hello,Thankyou for coming back to me,when I have mower on the back, the tractor Hydraulics fluctuate up and down,when it’s lifted,and you can hear like air around the back end and near the mcv near the hydraulic oil filter?
  15. 8

    International harvester technician

    Hi,I’m looking or hoping to find someone with knowledge of IH 885xl 1982, have a few problems,knowing that I could spend days if not months trying to rectify problems,where as professional would do it much better . I’m based in Somerset,so hopefully someone near,thanks for taking the time to...
Top