Search results

I'm looking for a pair of more narrow wheels for the maize drilling tractor. Current tyres are 420/85R38 and i'm looking at replacing them with 320/90r42 but these would be 40mm less in diameter (420 are about 1670mm, 320 would be about 1630mm) Would there be a problem with the 4 wheel drive?

The mice eat all the crops and live of their stubble for months. This is what they do to OSR fields around here if left unmanaged.

we have the same problem with mice, it's very dificult to get rid of them, especially if you have neighbours that don't do anything. we use bait (wheat or pellets) that we spread around their galleries by hand, others spread it with fertilizer spreaders (ilegal and expensive) but unless...

What makes the 7000 better on SF1? Do JD have a buyback program?

It has got the update when it came out, talked to deere man and he said there will be no more updates for this antenna. I use this tractor for cultivating, usualy set working width 15 cm less than actual width for peace of mind. I use SF1 for drilling cereals, soybeans and osr but for maize i...

thanks for the link, will look into it. what is the difference between sf1 and egnos precision wise? does it drift more than sf1?

I have a tractor with a Starfire 3000 antenna and since a couple of months ago i started having problems with the GPS signal, it keeps dropping sf1 and going to egnos, wich i can't use for steering. The antenna has been on this tractor since new, we don't take it off except over winter. Also, it...

yes, had to remove the ram. wasn't difficult after we realised how to undo the ram end

i had something similar on a jd6620. To check wether it was the steering ram or the danfoss, i placed a plastic disk in one of the hydraulic connections to the ram. The steering wheel could not be moved anymore in any direction so i concluded that the ram was leaking from one side to the other...

Is agopengps autosteer as easy to use as the other brands once it's set up? Does it have language packs for non english speaking drivers?

It got a little more complicated since last year, it needs a phitosanitary check and customs declaration, a customs comisioner might be needed

It would probably be cheaper for them to arrange the transport using local companies. That's what i did when i bought a bateman last year.

Has it been like this since new? Does this happen when running just a particular section or for any single section? What screen does it have? On Amaspray you need to set the number of nozzles for each section, maybe that is incorrect..

This is what jd uses for their tractors now, only they're screwed directly to the cab, not pole mounted

I already transferred all the diesel from it

Scrap it is then

I have a steel fuel tank that started leaking after the last fill. A couple of years ago, when i got it from an ex-farmer i had it cleaned on the inside and there was a lot of rust and orange peel like surface on the bottom. Can it be sorted or should i just scrap it? The leak is at the bottom...

Probably. I think there should be a code saying it can't build rail pressure

Yes, took it off, power washed it on the inside with hot water, removed and checked the outlet, let it to drain/dry for a few days, then put it back

I've replaced the fuel hose a few years ago