Search results

Serafino Winter Hybred Rye starting to move!

Exhaust leak has burnt two holes in auxiliary fuel tank! Just spoke to tank repair man, he wants to know type of plastic I cannot find any numbers on tank! Does anyone know if these tanks will plastic weld? Or is it scrap? Many thanks Jeremy.

How do you remove lower link sensing pins please as I need to replace both lower link arms as years on 6 furrow kv plough with packomat is ripping them off the balls! I've taken wire off and plate with bolts off but guessing it is seized? Any tips or special tools needed?

Drum belt vibrating about to break! Is it a job a can do myself? Watched online video said make sure variator is slowed position then wind some bolts in. It doesn't show them pulling pulley half off must be bloody heavy??? Or if just pulled apart enough you can slip new belt over and down in...

Any recommendations for roller shutter doors near Telford, need quite a wide one 8m. TIA

I have an old international 444 that I just use on flail topper for field margins etc. The hi lo sprocket keeps coming off end of shaft any ideas why ? I can't see a circlip or anything? The gears are quite worn. First time it happened I thought it could be my fault as I changed range whilst...

Just taken delivery of 8.2m He-va rolls with paddles boards. I cannot get paddles to work evenly?! Middle section moves much faster than outside sections and thus going too deep. Dealer fitter has just had a look and seemed at a loss as to why it is happening, I've tried obvious like bleeding...

Trying to remove lower link sensing pin to repair lift arm end where the ball is, as it is breaking up. I bodged it in past on the tractor but it needs to be removed to weld up properly now. I have removed two allen screws should the pin come out now? Do I need to remove circlip holding sensing...

I have a two bedroom cottage available for rent in Shropshire situated between Telford and Bridgnorth. Has brand new oil fired central heating as well as multufuel stove. Please contact me for more information or see Facebook link https://www.facebook.com/marketplace/item/705011140149446/ Jeremy

Have uploaded variable rate files to control box which is a kv tellus screen. The files have uploaded all fine, but how do I use the plus and minus seedrate option if I want to over ride seedrate map in certain areas? or if drilling gets delayed be able to blip seedrate plan up 10% etc? In...

Any ideas on why when I put the brakes on it is turning the side lights on?