SFA 324062.31 — No Axle Movement During Travel Although Command Was Given
Diagnostic trouble code SFA 324062.31 is saved when the control unit does not register any axle movement - via the position sensor - within 60 seconds during travel (ground speed more than 10 km/h / 6.2 mph), although the...
It just 4 wires goes to stepper motor. If wires demaged you should have some faults. Dealer should check connections and fault codes. Its last option to change stepper motor. Looks like that your dealer is waste of time. Who is your dealer??? If i need to do this job i will try to do hitch...
If arm "I notice my 6220 pulses when lifted all the way up." i will try to do hitch calibration. If hitch goes all the way up when press hitch button you neeed understand if you have fault in buttons or harnnes or somthing bad with hitch stepper motor. Ask dealer to check on screen or...
I can help if you need my help, but if guy dont understand that its JD drill block so good luck.
SteveO did you check coolant pressure? maybe its too much?
:(:)This guy dont understand that ball was blocked some JD drilling or some manual relief valve. There is no part where to buy this parts but he dont understand. I am techician and wish to help but now just need to remove valve and find part were is missing. I am 100% sure that nobody will come...
Good thinking. Just one think that many off pressure testing kits are made for cars not for AG. So there is no addapters to fit header tank. I have made some adapters for AG machine and still look on internet for AG kit adapters but no luck :(
As daveydiesel1 says it can by from PTO clutch pack or transmission clutch pack's. Did you use PTO? or did you notice that PTo on some load slips? Or did you nitice any noise or tractor stops on load when change gears?. Sometime its very difficult to understand. Once i have Case when PTO clutch...
How many from farmers have coolant system pressure tester?? It will be easyer to test for head gasket if you will use then Combustion leak detector cooling system tester. I think all farmers should have this :)
i was techician in JD company for 14 years. They will say if they can not see part on picture with i have send before so you CAN NOT buy. Dont understand why you write here?? If you want JD guys opinion just go to JD dearleship, or dont you have in Croatia ;). But good luck i will look also what...
you can not buy this part as it not showing in part manual. Your mechanic can try to find place whrom where it came and fit back, but looks like that square block should go tight. Try to look from breaker tractor.
I will say that you can not buy something like that. Looks like that it was blocking some channel (drilling hole). Remove TLS valve block and check all parts. See maybe you will see from where it came. Have attach picture with valves inside TLS block
Remove thermostat so engine should run cooler. Then when engine running look in header tank and put more engine speed. Coolant level should dip or put hand on top radiator hose and put more speed. Pipe should expand, it will tell that water pump is good. For better check you can buy laser...
Voltage on battery should by ish 12Volts. when crank engine should go to 9-10 Volts. Fit multimiter on battery and check voltage when you cranck. If its lower then battery is weak or starter motor is worn and using to much power. You can try to put jump leads from another machine to have good...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.