Search results

  1. Ollie6070

    The Fencing Picture Thread

    As said , cost is the main factor , when the creo ones are nearly gone I’ll replace with crash barriers and should have a fence with plenty of life in it for years to come
  2. Ollie6070

    The Fencing Picture Thread

    Anyone know if it’s acceptable to use creosote strainers with metal intermediates for fg2 grant fencing or can you not mix and match wood and steel ? Thanks
  3. Ollie6070

    Weidermann handlers

    Schaffers look good however our dealer said there struggling to get them currently and the wait is long
  4. Ollie6070

    Weidermann handlers

    Don’t make a pivot steer , weidermann basically is same components as kramer
  5. Ollie6070

    Weidermann handlers

    Error codes don’t fill me with confidence however all machines have their downfalls I suppose
  6. Ollie6070

    Weidermann handlers

    Thanks for that , it’s either a new weidermann or second hand jcb 320 with low hours however jcb looks a fair lump for around the yard so currently undecided 🙈
  7. Ollie6070

    Weidermann handlers

    Anyone on here got a weidermann 5080t pivot steer ? What’s your experience of them? And anybody ever pulled a trailer with them ? Thanks
  8. Ollie6070

    A few workshop jobs.

    Ah yes makes sense , gathered it must of been something along those lines . Thanks for taking the time to explain
  9. Ollie6070

    A few workshop jobs.

    And how does that work ? Never seen one in person
  10. Ollie6070

    A few workshop jobs.

    Out of curiosity @ Out of curiosity Larel how does the clamp work as it doesn’t use hydraulics like a solonet I see ?
  11. Ollie6070

    Why are these so expensive?

    It’s WH Bonds , near saltash , Cornwall
  12. Ollie6070

    The Fencing Picture Thread

    What heights everyone putting 2 strand barb wire fencing and distance between wires ?
  13. Ollie6070

    Tipping trailer ram location

    Haven’t got back to it yet due to a few reasons and having other work to do but I’ll get back to it at some point
  14. Ollie6070

    Spicer axle leaking

    That’s very helpful thank you very much I’ll report back with the outcome
  15. Ollie6070

    Spicer axle leaking

    Anyone ever done a spicer axle where it’s leaking around the drive shaft entering ? I’m guessing there’s a seal in there or something? It’s on a manitou pivot steer handler.
  16. Ollie6070

    Tipping trailer ram location

    I wish i could but the ram off the 12ft trailer never lifted it properly when it was in use, I’ve been told it had to be lifted by the telehandlef the first 12 inches then it would go plus the ram (badly corroded ) and chassis went to scrap
  17. Ollie6070

    Tipping trailer ram location

    Thanks everyone for your suggestions, I’ll explain my reasoning better : So I had two 10ft trailers with knackered body’s but solid chassis and a 12ft trailer with a knackered chassis but solid body and I’ve already extended the chassis using the two 10ft chassis to make a 12ft chassis to fit...
  18. Ollie6070

    Tipping trailer ram location

    Think what I’ll do is ask around and go and see another trailer the same length and copy that one that sounds easiest
  19. Ollie6070

    Tipping trailer ram location

    Yes that is correct…
  20. Ollie6070

    Tipping trailer ram location

    I agree , I’ve got a 14ft Marshall so I’ll measure the rams up on that and the location of them and have a think !
Top