Anyone ever done a spicer axle where it’s leaking around the drive shaft entering ? I’m guessing there’s a seal in there or something? It’s on a manitou pivot steer handler.
I’m currently lengthening a trailer chassis to accommodate a 12ft trailer body. Does anyone have any measurements for the location of where to put the hydraulic ram to get the correct angle for tipping the trailer? The ram is 920mm closed end to end and 2300 mm at full length Any help would be...
Hello fitted a lightbar to the roof of the tractor and have connected to wiring through to a relay with a switch coming off as well as a fused live and negative to the battery. The lightbar also had an earth which I connected to a steel bracket on the tractor. When turned on the lightbar comes...
Could anyone tell me what this fitting is called? It’s leaking where the 90 degree goes into the nut part. It’s on a new Holland going into the left air tank . Thank you
Currently using a evolution circular saw with steel cutting blade for cutting sheet steel lengths but need to change as I’m getting fed up with paying £50 for a blade that only lasts a couple of cuts so was curious as to what everyone else uses for cutting ?
Have oxy propane which can be used...
Got an old Strimech bucket needing the floor done , what thickness steel would people recommend, thinking 6mm? Going to be used as a second bucket for dung etc save washing the grain bucket, thanks for any help
Need to take some links out of the chain and slat floor on the straw blower , is rejoining the chain a case of welding a link back together or can you buy specific joiners ? Thanks in advance
I know it’s been said lots of times but I’m planning on fabricating a post driver. Planning on it going out to the side of the tractor, hydraulic tilt on top link and side of mast, around 250kg weight. Anyone got any picture of any other homemade or branded post drivers for inspiration...
Thinking of turning a Twose buckrake into a push off muck fork mounted on pin and cone brackets to make loading quicker when loading trailers and spreader, any reasons why this wouldn’t work ? Cheers
Need to weld a broken combine header reel shaft where it’s broken before going into the bearing any tips on how to get it so it’s running square and true when welding
Recently got a new gps which mounts on the window by a suction pad but I’m not convinced this is strong enough for the job any suggestions on how to make it stronger ? Cheers
Might be something simple but how do you release the pressure on a manitou (628? Think that’s the model ) pivot steer from the 3rd service male connections when putting pipes on thankyou
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.