Tractor will not going into gear or drive , starts up no problem but can’t actually move the gearstick to put it into gear no abcd lights in dash and no tortoise or hair lights rev counter also seems to not be working , have checked all fuses wire earths etc have had battery disconnected etc ...
Dynashift light c is staying on all the time even when ignition turned off any ideas anyone ? Thanks have checked bulbs and all fuses etc I can think off
Lift won’t work at the minute will work when manually push solenoids , getting flash code 1 7 , electric spools won’t work either but I can’t remember if the lift controls had to be unlocked for electric spools to work or not
If I were to get a 1200ltr trade waste bin collected every fortnight can everything go in?
bale wrap and net
Chem containers etc washed
All other dairy waste etc
And satisfy RT ?? Vertinary waste currently goes back to vets and I’m happy to continue with that , just sick of general waste...
Can’t get the lift to work atal ,
Changed rocker switch on armrest
Checked fuses on left hand side of steering colum all ok , will work when manual press solenoids on back end ,
No lights coming on atal on lift display ,
Anything else I should be looking at 🙈
Run a closed herd currently house all year round , currently vaccinate every 12months for ibr ,
Just wondering is it possible to vaccinate every 12 months
For bvd , lepto salmonella (small levels in bulk ) and ibr
Possibly with one shot vaccines and given all at the same time ???
Have been looking at a static wydale mixer with possibly a electric hot water tap above set to right temperature for mixing up milk powder , anyone with any better solutions/ anything for sale ??
Not for huge amounts of milk , possibly 20-30 calves when at maximum ,
Bought a new Connor wrapper last year ,
After every 40 bales in was blowing o ring seals out between turntable motor and a check valve where feed went it ........ back to deal was apparently piped up wrong for a closed centre tractor , got it back wrapped a couple hundred bales last year seemed...
Cheapest possible option to direct drill grass into burnt off ground ?? Possibly 20 acres a year ?
don’t mind cross drilling etc as long as I’m able to achieve good end result
I bought a tank second with the t200 control ,
Havin some problems with thermo and having watched the tank washing I’m pretty sure it isn’t rinsing the tank enough before washing with chemical ,
Has anyone any idea how to change wash settings etc ? I have no manual and it’s impossible to figure...
Currently milking danish jerseys , pure
Considering going dow the crossbred route,
Wondering what size of an animal I’d end up with crossing the jersey with a Holstein ??
housed intense ish system
Is it worthwhile for power consumption and light fittings etc to push for 200lux ? Cubicle shed needs rewired, 60ft wide 8 15,9 bays long 11ft eves with lean too down one side 16ft wide 14ft eve
Anyone any ideas best way to do it / what sort of figures I’m looking at ,
Surly must be a fair...
Currently have a concrete foot bath on parlour exit , it’s 7ft by 9ft a uses a lot of water and a lot of product , wondering should I have a smaller bath and use it everyday or what people think ,
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.