I have quite a substantial bit of plasma cutting that needs doing for an upcoming project mainly base plates, joining plates etc as I was thinking it may work out more economical to get them plasma cut then mag drilling myself. I need a good reliable company I'm in worksop nottinghamshire area.
Hello I am looking for someone that has drawings for a steel shed nothing huge that could share them with me if not does anyone do drawings with calcs. Cheers
I am after a bit of advise on whether to buy a cnc plasma or a flame profiler. I will be primarily cutting 10mm, 15mm and 20mm plate some hardox. Anyone own either cutting machines and could offer some advise? that would be great.
Thanks in advance
Which welder would you go for? Old inverter yes but which one? I can get a migatronic flex 400 for not a lot and I'm sure that is inverter based. Chap that uses it now uses it on structural stuff so it is calibrated but it is old ish.
Thanks for that yes I have seen a migatronic flex 400 with seperate wire feed but the cables from base unit to feed are only 2m can these be extended if I took it to a welding supplies? also can water coolers be retro fit as I would want the torch water cooled.
Hi I have recently started renting a workshop unit not for welding primarily but i do need to weld some hefty things now and again. Would I notice a big difference using a 3 phase mig compared to a single phase? I do have 3 phase in my workshop. Thanks in advance.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.