Search results

Yeah it's not self levelling, it has got soft ride though, would that do cause any issues?

No not that I've noticed it just clunk's to a stop

Filters were done 6 was ago. How do I check cable adjustment? I'll check the block . Thanks all

Hi all. I have a minor issue with my mx 80 loader fitted to my 4355. So the loader won't lift after a point when revving higher than 1400. A different point each time , and will go up again if I let it rest , then sticks again. It works on the linkage setting but not on the loader setting. The...

Hi all. I have a minor issue with my mx 80 loader fitted to my 4355. So the loader won't lift after a point when revving higher than 1400. A different point each time , and will go up again if I let it rest , then sticks again. It works on the linkage setting but not on the loader setting. The...

Back to the shop it goes ! Many thanks, much appreciated

Thank you, does that mean too little pressure , as needs oil? Or too much as in overfilled ? It is below the upper limit, but not by much. Cold

It's the same dash as the original picture. Many thanks in advance

Hi could you tell me what the top left hand warning light means on a 524 look like and engine with 2 arrows pointing at it

So as they get wider they get lower profile, therefore need to match profiles front and back

OK so I can go wider but probably should try to match brand front and rear?

34 x 15 So I assume they are 15 inches wide

Hi all , my massey 4355 is on 420 85 34 rears currently. The question is can I go wider with the same rims ? Thanks in advance. Mark

I currently have the hi bonnet which is a dream, and the power shuttle. The gear box is a 30k 24 speed , 3 gear ranges and one PowerPoint, terrible to change gear manually and the power shift is fine up but brutal down if pulling up a hill. Sounds like the 62 might be a nicer option to drive at...

Thank you

Are there any stand out issues I should be looking for with the 6245? Lights , electrics and aircon all work as they should , it's done a thousand hours more than my current 4355, 8k ish but I'm not going to put much strain on it, a bit of grassland work and a few small trailers of hay

Hi, I currently have a mf 4355 and wanted a 40k alternative been offered a mf 6245. Can anyone give me any insight to the pros and cons of each model please. Tia

Nope also added to the list for tomorrow. Thank you

Nope, but sounds like I have a job to do tomorrow 🙃

Can't see an obvious broken wire. Lights are all damp and that won't help but the working ones are as bad as the none working