Wake up to reality, Cant see this going ahead no matter what, In the light of whats happening in most countrys , this virus is ruthless and it has already got a foothold in the uk, 283 dead,
I have the very same problem on a case 140 maxxum, very aggressive start up when the back end is hot in the summer months, so much so it will brake the yoke end on a berthoud trailed sprayer, and shock load the fert spreader on start up, i have even got it calabrated to start slower but to no...
If it happened with no warning it is most likely one of the two speed sensors /flywheel input or gearbox output sensors the fact it tries to move is one of the symptoms had this a few times with new Holland TM and case IH puma and older 70 series new holland , it is very unlikely it's ECU lots...
It would fit very nicely into a curtain sider mind you. And God knows where it would end up I hope it's found soon.sites are notorious for machinery theft, too many know the routine.
My trams are supposed to be 33m but they end up being 31.7m running a 3m drill, slight over lap on every run I suppose,have to turn off end sprayer nozzles by hand once headland is done sometimes I don't boder depending what's in tank or if I am tight on application rate for given fields...
Often had same problem mostly as the lagoon level goes down low the suck up height is too great with thick slurry. Adding more water helps. To check for air leaks close everything off put into suck mode with tank empty run PTO for a few minutes stop engine walk to back u will hear air being...
Most slightly older sprayers only fill clean water tank with water hose for fear of contamination from chemistry in main tank on my sprayer one way valve fitted to pipe leaving clean tank. Because if level in main tank is higher than clean water tank, it could in theory back fill if u...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.