Search results

Anyone out there retrofitted the reverse drive to a valtra, in this case a T130 with mechanical linkages, Tom

I’m Working for a farm in the democratic republic of Congo that also runs a cattle ranch near kolwezi called Biano. From the description of the guys that have seen it (it’s a million hectares) it was run commercially during the colonial era and for some years after- they describe dip tanks...

So I’m looking at doing some fencing on some steepish land- too steep for the tractor, and from what I can gather from some of the old timers that used to operate cat dozers, would I be right in thinking that industrial machines or tracked tractors like a CAT d5b have bigger oil dumps than...

Anybody out there had experience of taking the Twintrac module and fitting it outside of the cab? The reason I ask is, I have quite an old Valtra T130 hitech that I use on a Bryce knocker, and it would be ideal to make the job easier without going down the tracked machine route. Any replies or...

The 6215 I’m using has come up with an error code along the lines of ‘lower link draft sensor position failure’ when I looked the stubb at the base of a link arm has a fair bit of play in it, the other side has non, Any one every taken it apart and replaced it etc etc? Help would be greatly...

I have a John Deere trailed sprayer and it’s on its second set of diaphragms this year, having done 5-6000 acres since they were replaced in the spring. It’s not left with spray solution in the tank overnight and washed out using the rinse cycles after every days spraying, Any ideas what the...

Got an old irrigator but recently have had to chop bits off the end because it springs a leak. Considering the amount of use it gets it doesn’t really seem worth replacing, anyone ever turned the plastic pipe 180 degrees onto the unworn side and reconnecting it to the reel and hose?

Using a John Deere 952i trailed sprayer at work and whilst it pulls in line on flattish ground or going parallel with the slope direction (it gets calibrated) it has a tendency to pull to one side when crossing slopes running out of the tramline by about 4-6 inches. Any ideas if there is some...

The Kuhn axis 40.2 ecm i am using is recording less product than actually used, even with quality products such as nitram, more has been applied by the spreader than is recorded on weigh counter, any ideas what is wrong with it? The picture attached was 2400kg spread but has been recorded as...