Search results

Any recommendations for an adblue delete boy, east central Scotland?

How is this done?

No. It has not had a software update.

Massey 7618 2013. Tractor is using adblue at around double the rate of usual. It has quite an easy life, sprayer etc but noticed the change when it was working harder. Anyone experienced this? Is there a cheap/easy fix before looking at a delete? Thanks.

Managed to bend a tine 🙄😂 Does anyone know of one of these on the shelf or if there is such a thing as non genuine? They can only be bought as a pair from the dealer. Thank you.

Another recalibration of the software has solved the problem. Thanks all for the replies.

Yeah. As I said above except for a couple of little problems this MF and Agleader system has been as good as perfect for 6 years. Tattys, plooin' in the hole, everything. Credit to Philips at Forfar for setting it up.

The Agleader guys have told me the problem is with the tractor. MF dealer has recalibrated the tractor system. I'm sure the problem is mechanical.

The system has been near faultless for 6 years. Just the odd small issue. I'm sure this is an easy fix. Just need to get at the the axle sensor I think. Will probably start digging in about the back of the hub as mentioned above.

Thanks. I had a look but couldn't see anything. Just a wire going into the axle half way along. Is the sensor inside? Does mudguard have to come off or more?

Does anyone know where the axle/wheel sensor is and how hard/easy it is to get at? Thanks.

The AB line is there and is 100% in the correct place. The tractor just won't sit on the line. I'll add that at less then 5km/h the tractor sits on or near the line but as speed increases to 10km/h the tractor moves across.

Perhaps? The receiver is fine and hasn't moved. The problem was intermittent which would suggest it couldn't be an input unless there is a bug in the screen and an input is changing?

2016 7720 steer ready with an aftermarket Agleader Incommand on RTK. The tractor is sitting approx 25cmm off the line always to the right. The problem was intermittent. I had this before and the problem was with the tractor rather than the Agleader system. Problem sorted out by dealer at that...

Does anyone know what the Speed Cal Factor should be approximately when taking a speed signal from a MF 7618 2013 tractor? Thank you.

I'm trying to set up an RDS Spraymaster 200. Does anyone have an idea what the Speed Cal Factor should be at? In relation to taking a pulse from this tractor.

It might be a problem with my radar. With a multimeter should the radar pulse be constant volts or pulse the volts?

Will this work with two wires only? Radar (1) or transmission (2) signal plus Earth (7)? Or does it need more than that? Thanks.

Does anyone know what the various pins relate to on the plug? In a Massey 7618. Looking for speed signal and earth. Thank you.

1/2" BSW (whitworth)