Search results

Hello all just seen these on e bay and did not know YL181s existed but here is the proof, has anybody used this type of board and how do they stack up against YL183s and 165s, the same seller is also selling some 175s Technophbia prohibits providing a link :scratchhead: E Bay item 313039811059...

Having trouble getting good furrow definition with TCNs tried slowing down and putting pressure on the boards and then taking it off, the ploughing looks nice and level and not paired but I struggle with leaving a clearly defined furrow

:scratchhead:dose any body here know what the trick is for setting a Ford 3000 front axel so that the front wheel side walls run in line with the rear at 52" centres for the rear wheels and ploughing on 11" furows, the problem that I have is that the front axel main beam fouls the wheel when...

Looking for some advice on size of counter sunk screws to replace the disc rivets on a Ransome's disc as I can only seem to get hold of 10mm thread size and the rivets that come out measure 11mm, I know they would have been imperial size but wondering if anyone has used a slightly smaller size...

Don't know if this is any interest to anyone on here, have just made this up and it might give others some ideas how to do a 90/91

Just wondering if anyone has any ideas for a floating stabiliser arm one that when the plough is in work will allow float and when the plough is lifted will lock the plough in the middle of the tractor and release once the plough is in work have a few ideas that I would like to try out on the...

I was given this the other day by a friend , thought it might bring back some memories to some of the older plough men on here, was impressed at how Ransomes went to all that trouble to present these pins in this soldered box, most people just used a bit of wood to hold the point on ! Nice keep...

Has anybody got any views and comments on this stretched TS 59 with a hydraulic operated cross shaft, any suggestions for the depth wheel, twin wheel or single would be appreciated

please remember these young men of all our wars but mostly the first world war, so many of them taken from the farms and villages along with their horses to shear bloody hell, please remember them !

Had these boards polished for a customer they came out great seeing that they were quite pitted :) dirty time consuming job and used a lot of sanding disc's doing them :( I know the owner will do a great job with them though :)

Has anybody any info on the proposed SOP rule changes regarding classic class mouldboard's, seems like there is some talk on a face book forum about some changes of use regarding Bonning and ycn in the classic class ?

Just wondering if anyone has herd or if there is any truth in the rumours on Kubota buying out Kverneland ? Herd this from a very reputable man today !

Nearly finished making these two ploughs one for a good friend and the other for myself would appreciate any input and comments on them they should both be finished this week blasted and then painted, I enjoy building and then adapting them nearly as much as using them any thoughts and...

Has any body fitted Ransomes YCN frogs to a Ransomes TS 91 plough ? don't know if leg holes will match up Was fitted with UCN frogs and now has TCN on it but would like the to fit YCN for some matches dependent on soil available if any one can offer any thoughts on this that would be great.