As I understand it Avara contracts allow growers to add in an increasing percentage of whole wheat to the ration as the birds grow where as Moypark only use milled feed.
Another thing to consider is that unless you are on nice easy working and well drained land it is a bit risky trying to establish AB15 after wheat. ( I know, I've got the tee shirt )
We have bent the rotors on ours quite a few times working on ridge and furrow and I have become a dab hand at getting them back to being reasonably straight. Procedure as follows,
1. Check the bolts holding the rotor are all present and tight.
2. With the machine on a tractor stood on concrete...
That is the account my 75% advance was paid from in January but is also the account used to pay me some more BPS money after questioning a 7ha underpayment, was your BPS less than expected.
When I asked this, although onto a C class road, a few years ago the Borough planning department said it wasn't their remit and referred me to County Council Highways. When I 'phoned them the chap I spoke to seemed a little bemused but said he would come out and have a look. On site he said...
I did the same as you and got a bit worried when I couldn't see this years claim even though they had acknowledged receiving it then I clicked on "Apply for BPS" and this years claim is there. Presumably it doesn't move to "past claims" until after validation or payment.
Try cleaning the breather plugs on the axles. If they are blocked air pressure increases as the axle warms up forcing air past the brake seals. The brake system will then need bleeding.
They'll get down when they are ready. I once had two limmy X steers go over the side of a quarry, we ran to the edge expecting to see them dead at the bottom but instead were surprised to see them running past some equally surprised digger drivers, go up an access cut on the other side and...
Look under the front right hand side of the cab, there is a wiring box that is susceptible to corrosion in the pins in the connectors Try cleaning and spraying with WD40 or similar. If the pins are too far gone they will need replacing, a few year ago I was able to get some new terminals on a...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.