Search results

Has any one used a QTP rock shaft kit they are a lot cheaper than nick young kits so wondered if anyone had used one and how it had worked out .

Looking for some tee jet 460 shut off valves and motors if any one has some .

I have a kuhn 5060 bedder and it wont always operate some of the functions . It will always work the bed and back door that work off the small valve block but the shoots etc on the large spool block don't always work the solenoids light up to say they are operating . Is there something worth...

Does any one have a claas volto 770 tedder breaking looking for a middle gearbox casing mine has broken where the wheel attaches .

I have a oil leak on one of the legs of our plough can anyone tell me the best way to disassemble to change the seals or have a parts book and post a picture of the cylinder on the back of leg .

I remember seeing at lamma probably 10 or 12 years ago various biomass boilers using cereals as fuel . Has anyone any experience of these would they stack up financially compared to oil for heating holiday lets .

Looking for a control box for a mf 185 baler or hesston 4755 .

I have just got a manitou 626 the brakes are not working and have been told it needs new seals due to brake fluid being used and not LHM is it possible to reseal the master cylinder with success or does it need replacing .

Wanted pair vertical fold bout markers to fit kuhn power harrow

Looking for con rods for a massey 187 big baler if any one has a baler breaking

Just got a 741 manitou the indicators are not working fuses look ok is it likely to be the flasher unit or something else .

My loadall has a problem with the rear diff i have dropped the axle off and it looks like the steering ram has to come off to un bolt the diff from the casing . is there any thing that needs be done to get the ram out i have unbolted the end cap removed the hydraulic fitting and tried to...

Looking for a shoot extension for a mengele 40 ideally shropshire or surrounding area but can arrange collection by courier .

I have just put a new throttle cable on my 530 70 but cant seem to set it up right if it idles at around 800 rpm it will only rev to about 1800 rpm if i get to rev to about 2000 rpm it idles to fast . what should it rev up to . any idea how to get it right .and out of interest what is the...

What is the best way to change one of the pipes that run inside the boom on a jcb 531-70 loadall . Does the boom need to come out or can it be done in situ and is it better to buy a jcb pipe or have one made up.

Does anyone know if a gear box from a old 4000 power harrow with straight tines fit a 301 with the two bolt tines .

I have to do some fencing on a mid tier scheme to fence some strips off up the side of the river . I want to use creosote stakes to do it but some one has told me you can not use creosote stakes on the side of the rive.r I have googled it but cant find any thing to say you cant and from what I...

Are keenan orbital spreaders any good for yard muck I have never seen one working and just wondered how people get on with them .

After a another antenna power lead for a lecia mojo mini if any one has one

Do the forestry commission ever do any fencing on there boundries or help by supplying materials we have a fair run that needs replacing and wondered if it is worth asking them . Also if we put a new fence up and one of there trees fall on it will they pay for repair .