Search results

Sounds as if the linkage has gone over centre.Take off the quadrant and rubber gasket where the leavers come through,then you will see a rod from the leaver going down to a triangular bracket amongst the dust and hay seeds.Take out one of the little split pins and have a fiddle with the...

About 15 years ago we all had to go on a course organized by the NFU to get a certificate of competence on how to load and transport livestock.If this course was organised by the N F U why is it not good enough for Red tractor? Boots

1000 red certas 64.51 Tate oil 68.66 Chesterfield area

Paid 1 .15 for red , highest quote was1 .18 today

I used a MF30 disc drill with every other spout blocked off .Don't put to much seed in the hopper at once.You need some one ridding on the back as the seed tends to bridge so as they can give it a poke with a stick when it does so. Don't drive to fast and it always came up fine.

I put a pair on the front of a loader tractor about a year ago ,and they have been fine.

Try the council leagle /solicitors department they should know about these things.

Ring your council footpath department they will then send you the relevant guidance notes and forms. Get a map that has your footpaths on ,mark them with some felt tip pens,Read notes fill in the form,sign the declaration,enclose cheque,post recorded delivery to council leagle department,job...

It is the hydraulic filter element. It filters the oil in the tank near the cab door.

If you want another working one I have one. Only stopped using it cos I bought a Krone disc mower. Situated near Chesterfield. Boots

I have a TL100 which did the same thing,After some head scratching the problem turned out to be a faulty ignition switch .Replaced it and job sorted.

Had a mate round today to get this sorted,and it was the battery senser cable broken where it goes into the plug. Have put a conector on to bypass the plug now all sorted. Thanks for everyone's input.

Had it split to put a new clutch in everything back together, works fine.but the battery doesn't charge and no ign light on the dash (Have checked, the bulb does work). Oil and air cleaner warning lights work. The alternator has 3 wires going into a block conector, and a single wire going onto a...

That rod with the knob on wants to be pushed fully rearwards to work the 3 point linkage.Pull it fully forwards for the external services.That diverter valve on top of the ACS valve looks like it is one way to operate the loader and opposite for the trailer tip pipe.The outer leaver on the...

I have a fahr km22 in working order,with good skid pans.Dont use it now as I recently bought a Krone disc mower. It is situated near Chesterfield Derbyshire Tel no 07977910934. Boots

I have a ford 4610 4 wheel drive deliver here new and that is a Ford New Holland and that was in January 1987.

It's a Ransomes I think they were made by petit trailers

Wanting to put down some hard standings and a roadway on a 5 van caravan site.About 8 inches of top soil on sandstone,if I dig out about 4or5 inches of soil then put down some Teram mesh then some crushed concrete and tarmac would that be ok.? Looking on the internet Teram comes in 1000,1500...

Sounds as though the linkage may have gone over center .take the dust cover off of the quadrant levers then you will see linkage ,it gets sloppy with wear I think the linkage only fits with little split pins.undo split pin then fiddle with tractor end and try to rotate it. Good luck

Order 1000lts red from certas delived next day 54.95