Search results

I chip wood for my own boilers , as part of this I now have to send in samples for testing . My last sample "failed "apparently chip size was not g 30 but did clarify as g50 . Firstly I think looking at the pile of chip they are wrong in this, looks pretty small to me and it all passes through...

I don't recall reading anything about this when we first signed up to the scheme . Is this changing the rules as we go along even legal ?

I don't recall reading anything about this when we first installed the system . Is this changing of the rules after we have signed up even legal ?

Having been successful in applying for grant for a few small items I tried to purchase item 207 P an air drill for establishing cover crops which was on the grant application listed at around £1990 with £796 to be awarded . I am unable to find anything approaching that price on the...

Yes , I downloaded the Ford manual and it does look pretty involved , just a case of finding someone with the knowledge carry out the repair, difficult with something of that age .

What should I look for if I remove top ?

On our Fordson Dexta the lift arms will raise all the way up when applying small movement at quadrant , they then lock up in this position under pressure until pressure is released either by opening up the external service valve or flicking the draft control lever up and down a couple of times...

That's interesting mine is a standard model , I know the Super Dexta had more power . Its a shame all the replacement dials are all for the later one as far as I cash see .

Looking to replace my Ford Dexta tachometer . There seem to be any number of new replacements but they are all different to mine in that 1 . Needle works in opposite direction to original . 2 . The PTO and Pulley speed settings are not the same , on original , PTO is shown as about...

Old post I know ,but do you have 11 t Iskra for Ferguson FE 35 23 c 4cylinder ?

Im looking at buying a PTO pressure washer . Ive narrowed it down to either 30l/min or 40/l /min gearbox driven . What are peoples experience of these machines and flow rates ?

Ive got a Redrock shear grab . The original tines lasted well but replacements from local dealer are given to bending or breaking . What are the best tines out there for strength ?

Ive got a redrock shear grab , the original tines lasted well , as I've come to replace them due to wear I've found the replacements from local dealer not as strong , given to bending and breaking . Im not sure what make the replacements are. What are the best tines out there for strength ?

Thank you , Ive found the fault code menu , the issue it seems is following recent work done to pipe work an overly long t piece was fitted to house the outgoing temp probe , this resulted in that temp being lower than return ! Understandably the meter gave a fault suggesting the probes...

Thanks , interestingly what you said about sensor position is possibly the answer as I have had recent work done and 1 sensor repositioned . I will let you know the outcome .

My Itron heat meter has stopped recording heat used , the flow rate and temp are both down on what they should be but obviously showing something is happening . Any one experienced this or any ideas ?

Although not currently allowed under RHI , going forward when this subsidy expires I wondered how different boilers perform on burning Grain ? I know the Guntamatic will happily burn cereals , any one had experience of the ETA Hack in this role ?

What are the differences ?

What is the durability of larch as a fence post ? I know it has natural weather resistance as cladding etc but wondered how it survived in the ground ?

Iv e got the Herz 199kw biomass boiler , Im constantly getting melted lumps of silica like material and clinker on grate which goes on to block the ash removal auger . Also not producing much heat . Im burning good dry larch chip so is not poor fuel . Any suggestions as to what's going on...