Grainstore concrete floor has big patches of moisture. Don’t think it had DPM when laid, don’t really want to re lay floor as not sure of long term plans.
Is there anything we could apply to block the moisture?
Just wondered what folks thoughts changing worn discs.
Our first set of big discs are pretty round, would you change them or run them on? Also would you change small disc or run them on for a couple of sets of big discs?
Many thanks
We have a fairly large sliding door at the moment, 9m wide 4.5 high they are in need of replacement and thinking about roller doors. It’s not facing the wind but would be fairly windy at times, any suggestions much appreciated
Fym at a very low rate, hardly see where he’s been, on probably some of the lightest, free draining ground in the county. Far worse going on not far from here
Yes brand new. Was meant to be here in September, not really an issue though.
Replaced a 13 plate 720 that was nearly faultless, think we will be keeping it a while
Thanks for replies
Yes, that makes sense.
I will look in the parts book to see if there is a gaiter of some sort.
When we got set up the emphasis was on even seed flow with the motor not going too fast if I remember correctly.
Will give them a ring on Monday
Seem to be getting seed coming out of this gap, should I be concerned? 250 kgs ha 6m 2017 with fan speed at what the book says.
First season with the drill so still learning. Any thoughts much appreciated
We have the same trouble, just doesn’t feed into the header really slow going trying to cut in the dark when losses seem much more acceptable. Everything else has cut so easy, shame really as the beans have looked a treat all year
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.