Search results

Our pressure washer works fine on cold If we use heat it will run hot until it reaches the correct temperature but when the burner cuts out the water stops a few seconds later .the red spanner light flashes and you have too switch off then on again and it runs until thermo cuts it all out Any...

Can anybody tell me how to calibrate a 3 point hitch rear linkage on a case puma 160

I'm working on a caffini 400l mist blower. It has a two speed gearbox and has shorn the input shaft twice has anybody else had trouble with this ?

Anyone know a good place for recon second hand trimmer parts pump etc Thanks

Has anybody found a sheet that works and lasts or are they just a box tick article it would be for 200x50 ft

The baler computer is set at 125 density but turns itself off at 115 every time.you have to switch it back on generally put net in on auto but doesn't always retract it?

I feel trailing shoe is better but will customers pay extra to cover the higher running cost

I feel trailing shoe is better but will customers pay extra to cover the higher running cost

Two questions my nephew is doing up a 4100 as part of his college coarse he's on a tight budget One is does anyone know of a pair of 36" wheels on six stud? Two. is there a way of getting the rev counter to work this tractor has got an alternator many thanks

I am trying to get the disc off of the spreader.ive got so far as the agitator shaft and can't work out how to remove it! Is it threaded onto 90 degree drive shaft or something any help appreciated

Can anyone help just done a full service but I don't know how to reset the service interval light?

Has anybody rebuilt the spreader rotor or know anyone who has? Failing that any scrap ones about

The machine was running but the boom started playing up so the machine was stopped. It comes up with stop now code d079 and it won't turn over to start All fuses by the door seem OK and 12.8 on the battery any help appreciated

I'm sure there will be similar post on here somewhere but a 550 drives the head fine when cold but when it warms up even changing power quad gear will cause it to loose power and stall out. Flick switch on and off and it comes to 3/4 ish speed and pressure any ideas? The oil cooler is clear and...

Could anyone please tell me what thread the nut is inside the trough that holds the shaft in place

The beval gear breather pushes out oil on uphill climbs and ideas why thanks

So I've got 12.6 on batt and starter little relay in fuse box click when I turn key but no ignition at all

Just a quick one we run new Holland tier 4 b 7.210s ATM we have just demo a t7.210 tier 5 has anybody noticed they seem noisy in the cab?

Just a quick one we run new Holland tier 4 b 7.210s ATM we have just demo a 210 tier 5 has anybody noticed they seem noisy in the cab?

Will a steinbauer chip off a t 7.210 tier 4b work on a T7. 210 tier 5