Search results

  1. M

    Challenger 55 transmission fault

    Friend has a class challenger 55 which has been faultless and worked perfectly, but after being parked for 5 minutes now refuses to move, nothing doing at all, he says moving steering causes tracks to move but not trying to move with transmission, he hasnt mentioned error codes etc.is there...
  2. M

    Kleber 300/95r52 tyres

    I am looking for 2 new kleber 300/95r 52 tyres. I have had them in the past but last set were alliance and these were poor ride compared to klebers
  3. M

    Valtra 8950 soft brake pedal

    Our 8950 valtra is suffering from soft brake pedals. We have replaced the slave cylinders on top of the rear axle which cured it for a very short while. Pedal will work ok and then next time less pressure and will travel to bottom.nothing wrong with the brakes themselves if you pump pedal brakes...
  4. M

    Maxxum 5130 syncro

    Friends maxxum 5130 syncro lift will only operate by using the rear mudguard buttons. He has replaced the switch in thecab but this hasnt made any difference console is off and done o lot of checking of wires etc but have not found any thing obvious tractor never spends a night outside and has...
  5. M

    445/65r22.5 tyre

    Would appreciate a quote for 445/65r22.5 tyre for ag trailer delivered to L40
  6. M

    Deutz Fahr 4045 Combine

    My mates 4045 starliner combine is driving him mad. At the moment with damper than usual grain the tank auger refuses to begin unloading the tank it jams and can only be rectified by removing the plate at the bevel before the grain rises to the swing out unloading auger,and removing some grain...
  7. M

    MXU 135 ACCELERATOR

    I have a 2004 Case IH Mxu 135 which is giving foot throttle problems. Foot throttle stops working, hand throttle ok, starts working again if key off/on quickly or stop and start again. Have realized recently that it does not do it until tractor is warmed up. we have replaced foot throttle unit...
  8. M

    Lemken Mouldboards

    After 5 right and 5 left B25 h mouldboards for DL120 plough delivered to L40 part no 344 1026/7
  9. M

    CASEIH Cvx error code

    Mate has a cvx 1170 wont move and is showing SGR on display Any ideas
Top