Search results

Hi, I’m after some help, just had our drill controls upgraded to a muller isobus system. Works great on our isobus screens except the case Puma pro 700 screen. I’m getting this message on the screen. Has anyone got any ideas. Is this a case problem or a muller problem? Tia

Thanks for the links. They are the sort of thing I’m looking for. Yeh I figured that they wouldn’t be the cheapest even though they are offering to swap everything over for you. It can’t be that hard to set it up?

I think up to £500 - £600 pound would be a sensible price range. I looked on the gatekeeper website at their suggested laptop and nearly fell over at the price!! £££[emoji102]

Hi, looking at getting a laptop to replace our old secondary computer that is still currently running gatekeeper. The old computer is getting pretty slow and also is still on windows 7 which isn’t being supported by Microsoft anymore. Looking at a laptop as a don’t live at the same yard as the...

Just tipped the first load of wheat at 15%. Drying quite fast, started at 17.5% at 1.30pm

That would be fantastic. I’ve tried to send you a private message but it won’t let me.

I believe they don’t exist anymore. I think Chief are the ones to go to now regarding the Law Denis. I’ll give them a ring if I need any more info. Now I’ve got that page I should be ok. I know the dryer pretty well otherwise. Been running it at 105 degrees all day and seems to be going...

Thanks that is just what I’m looking for! I would say we have the same machine. We did also have trouble with the burner a few years back and ended up replacing the burner control panel. This is the current state of my version of that page!

Thanks, the majority is 17% with the wettest being 19%. I did the feed barley at 95 degrees, which I did think was a bit keen but flew through without a problem.

As the title suggests I’m after some advice. Been running a Law Dennis 20t continuous grain fryer for a few years now. It’s great but I can never remember year on year the temperature setting precisely to get the best out of it. Usually I refer to the manual but I’ve had a bit of a mishap with...

One pass with Simba heavy discs as soon as after straw is cleared/muck applied. Then let weather, spray off and drill. Only plough as a reset on bad black grass infested area. So I guess mintill, would be to deep with discs for scratch till.

Yes and it’s in a slot through the chassis so you can’t get to it any other way. We ended up cutting it out from the bottom and then making a tool to fit the head from underneath. 5 minute job turned into 3 hours very quickly!

Winter variety about 5.5 - 7.5t/ha. Price is good too, they are usually about £30 above feed wheat price.

We've been growing winter naked oats for the past 10 years, and have grown some spring naked oats on occasion. Have always found if you round up them off before harvest the straw breaks up better through the chopper but we tend to bale most of it now as we find is a great feed. Local dairy...

What accuracy of gps did you run this on? Egnos/rtx/rtk? Also did you still run the LH5000 monitor along side this or was it all integrated to the Trimble?

Ahh that's makes sense on the switch. So does anyone have any idea what sort of system I could put it for guidance and then section control. I quite like the look of the Trimble cfx750?

Hi Recently updated the sprayer to a Bateman RB25 in the spring. Brilliant price of kit especially compared to the old Hi-Lo! It appears to have been fitted with gps/autosteer before? (See photos) I've been looking at using gps for a while but haven't got much idea on the job apart from what...

Ok I've PM'd you

Hi. Where are you?

No sorry it's sold!