Need to know Gents if anybody has had the error codes T 151 and T 153 on Massey dyna 6 7626 50 k box, book says braking pressure to low. Tractors about to be looked at by dealer, they say they need to run tests to find problem any advice l can get would be appreciated the quicker they can fix...
Hi all, a friend of mine recently purchased a new Kubota m135gx it had only done 100 hours when high range in the gearbox locked up a full road speed damaging a fair bit of the gearbox and diff. The tractor was pulled apart repaired and sent back to him, 10 hours later its done the same thing...
Just wandering if anyone has had any experience with the MF 8700 series. Reliability, performance, fuel economy, comfort etc, any information would greatly appreciated. I have been offered a really good quote on a new tier 2 8737,thanks in advance. Cheers
Need some advice Gents, l have a t3 perkins 6480 around 3000 hours thats become very hard to start. The starter and batteries are fine and does not burn oil, fuel filters changed every 300 hours. It is easier to start when warm but still cranks more than it should. Will ring dealer first thing...
Ordered a new Kubota M135GX today, trading in Massey 4270 needed a lightweight high power to weight ratio tractor for ground work in winter time. Priced it against dyna 6 Massey 6713 $22000 dearer than Kubota and Massey is well over a ton heavier. Fingers crossed all goes well.
A mate of mine has just brought second hand kubota M135X with a low 1100 hours, l was just wandering if anyones had a good or bad run with this model kubota....cheers
I have the same problem come up second time around now, just wandering weather any body else has had the same problem. I have mf t3 6480 that had the crown wheel and pinion replaced at 1500 hours due to scuffing on the reverse side of the teeth on crown wheel, when pulling forward its as quiet...
Hi fellas, has anybody heard any dealer rumours in regards to AGCO dropping the 7 cylinder sisu into the big fergy 8 series. Just curious that's all looking at the torque figures on the challenger 7E series it would make one hell of a ballsy tractor.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.