Does anybody have an electrical diagram? Key switch will allow starter to engage but fuel solenoid not getting power or shuttle lever. Someone has been butchering in their before would like to leave it back to original. Any help appreciated.
Have a heifer carrying a back leg, vet said it was spastic paralysis, a nerve issue apparently. It's not in pain but don't know what to do with it. Can it go to a factory? Doesn't really put weight on that leg. Any thoughts....
Anybody know what the plate behind the water pump is for? Came with a new water pump but not in the tractor currently on old water pump?? Does it need it?
Anyone growing this?? Apparently it can be composted to produce a liquid fertilizer which is equal in NPK. Might be worth a go, however the plant looks very like a dock.
Seen a tidy 06 manitou 634-120lsu for sale. Have read the horror stories regarding the 90degree box. Has anyone a video or can the noise be described, does it be noticeable at idle or only when the boom moves. Sorry only have had JCB or matbro machines..
Would anyone know where else the ball joint used to drive the cutter bar could be sourced? Is their another machine or vehicle which uses it. Problem is mcconnel want £220 for something that should cost sub £50
Anyone know what causes the entire dash to light up and stay that way? Have checked multi plugs for corrosion and earth is ok. Is their a way to reset it?
Anybody have opnions on these older Hyundai's looking at a 1998 one seems reasonably good and reasonably priced. Also is their an export market if it's a bag of nails?
Got asked to take a look at a 2040 that wont select high range but takes low and reverse in all gears. It is an sg2 with gears at side. Took lower pin out and gear stick moves into position freely so must be an issue in gearbox. Anyone come across this before?
Got asked to take a look at a 2040 that wont select high range but takes low and reverse in all gears. It is an sg2 with gears at side. Took lower pin out and gear stick moves into position freely so must be an issue in gearbox. Anyone come across this before?
Had a look at a 725c today with a view to buying it. Anyway the guy said the hydraulics were a bit slow but had been sitting for a long time. So started it put the boom out and it wouldnt bring it back in. Also steering nearly locked solid. Boom wouldnt go up or down but crowd function worked...
Is their anyone close to Inverness who would take a look at a JCB 526S for me? Its not a dealer just would like to verify its not a scam ie no mechanical knowledge required. I will pay for your time as I dont really want to drive their from Northern Ireland unless it does exist.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.