With the price of new sheds always climbing I wondered on building my own. Got all the facilities and good welders on hand. Is there a booklet or information available anywhere for steel sizes and pitch for various sheds? Might be going up to 100’ spans so not wanting to get the wrong size steel...
Just away to concrete a bit of the yard. There will be lorries on it. Thinking 250mm deep of r35 air entrained concrete with a393 mesh at the bottom. Unsure whether to get structural fibres as well. An extra £18 a cube for them. Not wanting to do it again but is it overkill?
Hi all. Just gotten a 13000l tank with frame and planning on using it on the low loader. Just wondered how anyone else holds them down to the trailer other than straps over the top?
Well this is my effort of a cattle handling setup. Done it ourselves apart from rolling the box section for the forcing pen. Still a few improvements to do with cow flow. Need to sheet the forcing pen and race so cows can only see where we want them to go. Plus concrete to the edge of the sheds...
Hi there. I've got a 24 cu m trioliet twin auger wagon. Had it for a few years now and has always been a hard thing to power. 130hp valmet is normally on it and starts to puff above 4t of a mix. 230hp Mccormick is fit for a 6/7t load but just burned out the second set of pto clutch packs...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.