Anyone ever had wire break like this before? Had this in 2 spots were barb and rylock split, along with a few spots where the bottom 2 wires are broken. Has it been cut or is it possible for it to break like that?
Currently on the look out for a header for our claas 204 if anyone happen knows of one kicking about?
Or if its possible to make a header from a 6 walker machine fit a 5 walker?
Cheers
Afternoon all, cant get any of the boom functions to work on the sprayer, up down fold or tilt. Was working fine last night but today nothing. It ciculates oil fine until you press a switch to move the boom then it makes the tractor work, there is power to all the solenoids and can hear them...
Just bought an overum plough that has been snapped and re-welded at the headstock (arrow in 1st pic), just thinking would it be worth adding strength to the shaft it turns on, maybe welding another tube inside the main one,
Cheers all.
Thinking we may have an electrical fault... combine wont engage the header drive or the spout, thresher works but when header switch is engaged it cuts the thresher out, anyone ever experienced any of these faults, cheers
Having trouble getting the swr set in the fresh tractor. Think the likely cause is that ive got the antenna mounted low down for going in low sheds, but it sets up fine with a 5ft firestick antenna. Wondered if fitting a shorter firestick could work just as well or would it lead to the same...
I know its not ideal but would it be ok ploughing in a field spread with fibrophos? Was aiming to put it on top of the ploughing and got some going on before min till, but with the recent rain traveling on ploughing is looking like a no go...
Cheers all
Having trouble getting the tank light to work on the mega, dont think its a wiring issue but wondered if anyone knew where it gets its power feed from, or another reason it may not work.
Is it possible it will only work with thresher in gear and running?
Cheers
Is it a big job to change the discs and bearings? Our utah 250 has just had a bearing go on one of the disc axels. The discs are all about knackered so thought now might be a good time to change them all.
Not had them long so dont know much about them, just wondered if there was anything we may...
Looking at getting a front linkage for our landini powermondial, thought about 2nd hand but coming across one for a landini is near impossible. However i have seen one or two to fit a mccormick cx or mc, far as i know these have almost the same engine as our landini. Just wondered if anyone had...
Just comparing two buckets for the ewes pre lambing, looking at the numbers one looks better than the other, but is more expensive, just wondered if anyone could shed some light on them,
Cheers
Hi,
Our 856 has a problem with its trailer brakes, where it seems to have constant pressure to them, meaning it locks the brakes on as soon as they are connected.
Anyone able to advise, cheers
Have a cb in our combine which, for some reason when the mic is pressed it sets the alarms off for low speed on the elevators:scratchhead:
Not sure why its doing it, thought it could be the power source so moved it to the sideknife supply which is straight from the battery but still no...
Morning all.
Might be looking at a centreliner sx, just wondered if theres any way to tell what width its set at by looking at it? If im right in thinking its the same as a teagle centreliner it will be swap the gears to change the width? Or i might be wrong:)
Cheers
Seem to be getting alot of lambs with watery mouth this year. Anyone else having bother?
What do people do to combat it?
We started off aiming to use less antibiotics but now are dosing every lamb:(
Pens are cleaned out after every ewe, all kept well bedded, been using lime and disinfectant...
Have 14 acre of bean stubble that we are just debating weather it would work to drill wheat in with mzuri. Intention was to disc then combi, but stubble is longer then i would have liked so not sure combi will cope.
Wondered about getting it done with a mzuri, would be first attempt at strip...
Hi
Got a couple of fields we are planning on taking out of grass this year and putting in WW. Just out to pick a few brains and get some ideas on best way to go about it.
Fields are on a hill top and are very sandy land that jusy goes to dust when worked.
Going to test for lime but im...
For wholecropping beans when would be the best time to take them? And is it best to put them through a wholecrop or maize cracker on forager or just straight through?
Also is an additive needed?
I dont ask for much do i:rolleyes:
Cheers all
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.