Fan Speed control on our John Deere 6230 playing up at moment goes sometimes then not at all !
It's variable speed ,sometimes at full speed is only running the fan at half speed anyone else had similar.
Thinking the control potentiometer or loose connection and how do I get to it?
Looking for a replacement alternator for a catapillar v40d forklift it has the perjout engine
It has at moment a delco Remy 110291 61a 9mo5 12v neg anyone know of replacement?
Wondering if the collective could pass opinions
I have a shed nearly 10 years old and roof sheets are peeling plastic coating I have contacted firm that built it and thay say the sheet supplyer has gone bust do you think I have any chance of repair from firm that built it
Having problems with ignition on our 5613
when stood for a while there is a battery isolator switches all power off
I think it could be faulty as ignition does not always come back on everything in cab dead. switch ignition on and off several times it finally works where is it and what's the...
Don't know where to poast this no doubt somone will tell me
Looking for a holiday let in Northumberland area this Fri to Monday anyone got anything or know of one thanks
My local dealer was telling me this morning that there is a rush on to export machinery to Ireland and Poland before January because in2021 all exports will have to be thoroughly washed and will have to be inspected by a vet!!!
Mad or what
Hi there I have a massy ferguson 5455 on 04 plate occasionally when I put my foot on right brake it puts power shuttle to neutral with direction lights flashing putting shuttle to neutral and back to forward all ok does not happen with left brake anyone else had this?
Hi there
My wife suffers with farmers lung can't go any where near the onion store or grading shed as onion dust sets off a reaction, anyone found masks or treatment that is effective?
Hi i have a 2.5ton Toyota industrial forklift truck been very little trouble until last week
The sas stability light is on more than it used to be on dash and the stability ram on back axle will suddenly move quickly sometimes light on dash is on for 10 seconds before ram moves
Am thinking...
Not sure if this is the right place but in market for a mig tig welder with possibly of a plasma included any recommendations or reports
Looking in the £500-600 bracket thanks more if plasma included thanks
Having problems with charging checked cables to altornator
Feed connection was frayed recrimped new connector
Wire goes into a black plastic piece another wire goes onto frame of altonator and male pin on other end does not have circuit through from male pin to feed but 350ohm to earth is this...
Had a stud shear off on exaughst to manifold so stripping down to replace
3 questions
1 is it common for manifold to warp on perkins to pop off stud nr turbo
2 Should turbo shaft have any movement (it has a little) have noted a whistle or baring screech occasionally at 1500rpm when not working...
Need a little advice on massy 390 clutch
Installed a new clutch a few years ago at the time of fitting had to use longer bolts on clutch fingers to get it to clear properly now at end of adjustment can't adjust clutch to clear anymore usually when plate is worn pedal rises and knee is behind...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.