Search results

I also have the r tech 50, my view is same as already mentioned 13 mm is about limit of good cut. For price I think it's a good.

Saw one of these in local shop, it looked good for tighter spaces than G coupler. I think it was £27 which I thought it was a bit expensive tho.

Have a parweld (I think 160) from welding supplies direct. Have run it off a 15kva generator fine. It's a nice machine.

Local drainage board, just had to drain fuel tank completely and change fuel filters. Then fill up with white only

Also if ur not fussed about colouring area covered, just put machine width at a third. That's what I do with 750 works for me

It because its a 750! Not sure about ez-steer I think it does but been a while since I've been on it but ez pilot will definitely drive first headland with fmx/fm1000

Screw type. And blue no.2 hasn't got any wire to it.

I'm looking to expand my rtk network, at the moment I cover most of Nottinghamshire and a little bit of west Lincolnshire. So if anyone is in the area of South Yorkshire or North Lincolnshire and is interested in using a trimble rtk signal please pm me to have a chat.