Search results

I ordered the part and this turned up this morning, the images on the website show a plug in the middle, which I had assumed would come with the part. Obviously not! What do I need? @Tractortech has talked about a blanking plug, is that what is required or should it stop oil flowing between the...

So do I get a V8008 KONTAK CC END COV C/W OUTLET PORT to replace my plate with the Kontak name on it? @Mr Happy @Tractortech @C.J Advice much appreciated Thank you

Other end! Most definitely a Kontak spool block.

I'll get a photo of the opposite end tomorrow. So general consensus is that I need a V8008 KONTAK CC END COV C?W OUTLET PORT not the V8010 which is the photo below in Mr Happy's original post. Talked to White House products today about a V8010 (bottom photo) thinking that was what I wanted but...

The end plate on the spool block definitely resembles the V8008 Kontak CC END COV C/W Outlet port shown in the second image posted by @Mr Happy. I will contact White House Products tomorrow and find out about one. Thank you

Thank you very much, will the valve block be stamped with a name? I'll take another look, remove the nettles!!

Good evening, I have a Bomford 457 Hedge Trimmer which has a spool block set up for open centre hydraulics. I run it on a John Deere 2140 which is closed centre hydraulics. Is it possible to convert the spool block to closed centre? Having read a few hydraulic threads it would seem @Mr Happy...

There does not seem to be much wear/play in either linkage to either spool. What is the rack housing?

Returning to this issue, I find that both spools valves will extend a ram really quickly, the second spool returns really slowly and only if the lever in the cab is held in a certain position. The past few days it has started to stop while holding the lever when pulling in the ram. Is this a...

I have two spool values in the cab, four couplers on the back of the tractor, a pair either side of the top link. The spool nearest the mudguard/window has the issue.

Thank you for the replies. The reason I asked is because the second spool on the tractor doesn't seem to work well. By this I mean it will happily push out a ram quick, but when asked to retract the ram is very slow and you need to mess about with the spool lever to get it to do that. So maybe...

Does anyone know where I could add a free flow return on the back end of a John Deere 2140? For running a bale wrapper or log splitter for example. Thank you

Announced on the RVT tractors Twitter feed

Yes been announced on Twitter

Ransomes 51 Marquis cylinder mower for sale. Used to use it to keep the lawn looking incredibly tidy and short. Has a new fuel tank, runs well. Still for sale.

Very impressive bit of kit, can you get them in the UK?

Ransomes 51 Marquis cylinder mower for sale. Used to use it to keep the lawn looking incredibly tidy and short. Has a new fuel tank, runs well. Started this morning in a couple of pulls after being fuelled. Not been started for a while but mowed ok. £150 buyer collects, its large and heavy!

Hello, what condition is yours in? Do you know it's age? Is it a red or a green one? Thanks

Sold

True we could refit the drum back and weld it in place. Ironically it was the good drum that parted company with the mower. The bottom disc on the other drum is not spinning freely. Hits something internally. Looked at trying to take it off to investigate but studs holding it on are too tight...