Search results

Hit gear on, didn't just pop out but got it out. Needed alot of heat to move the gear which doesn't go well with balers and hay knocking about. Just the gear to pull off now, borrowed some big puller's so here's hoping it won't be too bad

Did u cut with gas or grinder??

Hope it doesn't come to that

Yeah

Anybody got any ideas how to remove a gib key off a gear, tried a tapered tool to slide it out but didn't work, just about run out of ideas now

Its fine on other tractors

Its a renault 90 14, seems to happen with the tanker on it and the whole tractor seems to bounce

No its an old tractor, just wondering if it could be a clutch issue

Drives fine with nothing on but kinda bunny hops with anything on the back, any ideas???

Has anyone any experience using high temperature (600°) silicone with exhaust gaskets to stop it blowing?

👍

Get a multimeter on the plug for the buttons and see if you have power 1st

Get a multimeter on the plug for the buttons and see if you have power 1st

Wheres that at?

Not those bloody buttons again

In the cab on the right hand side of the dash, does anyone know how many things fuse 32 supplies for, it keeps blowing and have no link arms without it, so trying to eliminate what might be at fault. Thanks in advance

Please help me, tractor was running rough, cleaned lift pump and changed filter, was abit of a mess in both, started it and will run fine but nothing over about half throttle. Any ideas?

What are can lines?

Any help gratefully appreciated

Is there a none genuine cab floor mat for these at reasonable money?