Hi,
I’m looking for the wider 935mm square cross for my ME match plough or even the shorter 825mm one to cut a bit out of
Cross shaft is 70mm x 38mm .
Anyone got one for sale ?
Thanks
Good evening,
I’ve recently bought a 2003 4355 which I think is definitely down on power, I drove my friends 4355 which is the same year and similar hrs, his one is like a pocket rocket compared to mine . I’ve changed the fuel filter and checked the little pencil filter in the lift pump (which...
Could anyone confirm where the distance of 320mm for the tailpiece from the mouldboard is taken from
1/ the original mouldboard or
2/ the extension piece I’ve welded on ?
Thanks
After finishing my first ploughing season with the ME, I’ve come to the conclusion that I’ve got to alter some settings, the pitch being one and cutting some more off the bottom of the mouldboards (I’ve already cut 1/2 inch off), I didn’t have to do anything to my super Hydrein I had before ...
Good morning,
I made some lovely small bale Haylage this year for my daughter’s pony, I’m of a view that once open, cutting the plastic at one end to form a lid, take out what you need and then wrap it up to keep the air out and to keep it fresh . My daughter started doing this at the stable...
hi,
I’ve got the above and it’s dicking about locking me out of the hydraulics, especially with a full cube of concrete in the bucket. I can carry on by turning the special lock out key but it’s a pain.
I’ve cleaned out the rear axle sensor and it cured it until today when I was concreting...
just had a customer wanting us to repair a grain store floor that’s got cracks in it from having had a burst water pipe going for a month or so near by, the floor heaved, cracked and then went back, the cracks go upto 25mm wide, I was thinking of using JCP polyester resin JF380PSF, I know that...
Looking to buy some self locking yokes, are there any other makes out there any good, they will need to fit onto .5 metre high flat top concrete panels in 6m bays, I don't want any wood involved in the panels, I like the look of the Bateman one but would appreciate users recommendations and...
I see on all the 'professional ploughmen' that they have a hydraulic ram replacing the left lift rod, are these all home made or is there anybody making them, if home made do you need check valves or taps to stop movement whilst ploughing ?
TIA
Hi,
I was reading some farming press recently (can't remember which one), and there was an advert by I think some farming folk that were importing some Australian gaiters, there were different types, after getting the odd stone in my new steel toe trainer's I'd like to get a pair but I...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.