Search results

Any experts out there on the hc 8600 controller? Why today has it stopped colouring green the area sprayed? Logged the field ok, started and switched off boom ok.

Anyone know what model fergie this type of seat was originally fitted to?

Will an MF 875 loader fit an MF 390T 4wd Tractor? Normally see 880 loaders on em

As per title really, which is the best product on the market for use on ag machinery?

Another harvest clocked up for the old girl

Now that they have been out for a while, what are drivers/owners views on the big 4 cylinder Fergies?

My 6290 isn't governing quite right. Mainly noticeable when shunting around the yard at low revs, when you are reversing up to a trailer for example and are on and off the clutch it can float up and down on revs a bit. Any simple fix or is a pump off job for a an overhaul?. Cheers

Dropping the rear end oil out, can't believe the drain plug is directly above the puh pivot pin. Am I missing something or are the MF designers that useless??

Anyone out there know of a Club root resistant Clearfield OSR variety either out to drill this August or close to becoming available ?

I bought a Dewalt 54v XR cordless grinder 2 years ago, excellent tool and has had quite a bit of use. However today when I squeezed the trigger nothing happened. I found if I spun the disc then squeezed the trigger it would start and run ok. After a while it would only run for a couple of...

Anyone go? Wondered what the 2.5metre Sumo Trio made? Too busy drilling to go

Chain oiler on the New Holland baler has stopped working after it ran dry of oil. Anyone know how to bleed it? Thanks

Anyone out there with a "Bale command plus manual" for sale? To use with a NH 644 round baler

I bought a heater plug for my TEF 20 off ebay, yet it is too long. The few that are for sale on ebay all appear to be 65mm long. Does anyone know where to get a correct one that will fit?

Looking for a tidy, low houred Massey 3120 if anyone is thinking of selling?

Looking for a pair of rear wheels for an MF 3060/3070. 16.9 x 34 must be in good condition

Looking for an engine rebuild kit, anyone used these? Any problems, they seem competitively priced compared to a genuine dealer price

A red version of the BR740, did it have a fork feed or a rota feed system behind the pick up??

Soon time to change power harrow blades on the Kuhn., any opinions on hard faced ones, prices,the ones to go for etc??

can anyone tell me what the E100 error code is??