Run a 2022 Stealth 4m here standard he-va points don't last long especially last year so we got some with tungsten on the wing and they did 300acres before I got some APM maxipart ones for this year which have done just short of 50 acres with no obvious wear but they do have a more square...
I have a couple of SOLO 434 backpack sprayers which I highly rate, they aren't cheap but do have a 4 stroke Honda engine and get some serious pressure on which we use for vines/trees/glasshouse work. Also comes in very handy for pre harvest spray down of the grain store.
No problems with them at all, did plenty of shear-pin sections but we have some heavy riverside clay and it was an exceptionally dry year so to be expected.
You can't get them with full tungsten wings these are just tiled on the leading edge and then the wing is ridged to help with wear we looked at the other version with hard face welding on the sides and and thought it would make the point wider and do more disturbance. I've attached a picture...
Got ours last year fantastic piece of kit well made and designed. Only thing we found was standard points didn't last as long as expected but some tungsten sorted that and now use APM ones.
Completely original 90 G reg still on original goodyear super traction radials 7300 hours. I've put complete clutch and flywheel plus been in back end to re seal internal lift piston. Pressure tested all circuits at the time and all OK. It was a bloody good investment when I bought it. Just need...
My old 3050 doing her bit before the weather turned not posted in a while but been following with interest. going to put her in the workshop and get some winter jobs sorted needs a full engine service, fan belt and hydraulic pump drive donut replacing as it's chattering a bit.
This finally turned up today 14 months after the order process started very nice to drive first pickup since a bad experience with an Isuzu Rodeo. There is a subtle difference in the 2 photos which most people seem to do.
Agristar 40.7 evo 2
Yes as soon as machine got swapped for new identical machine after 18months of terror we traded it in for a JCB and that’s been a good machine so far 3years in.
This was a automatic dpf clean whilst working light on corner post whilst machine working as normal not forced regen. Never had to do a forced regen on any ones I’ve driven. Just giving OP time between cleans as he asked.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.