Trying to get heifer slurry to a lagoon 220m away with 11' of fall. On with constructing a conc 6000 gallon tank to scrape into. This is 5' deep. Thinking of a pipe out of centre of floor which will drop 6' over 20' length then the rest will run level.? Will this work??
Should have been in workshop projects...
Neighbours cattle trailer chassis, my homemade splitter, imr forklift engine, grab wagon pump to go on bell housing,and hydraulic tank off hooklift gear... Fast tow, low fuel use,and no financed tractor depreciating at £10/hr...
Only things I don't like about current bus is manual ( no good for drinking a brew in morning) and gutless...
Love the build quality and general workman like use ability ..
03 reg hilux always been flat as a witches tit, put up with it for 3 yr... Do I bite the bullet, add 5k and go newer for an extra 60bhp instantly or tweak what I've already got and is pre dented to match my work style...
Matbros e reg. 4 speed with left hand shuttle, ford industrial engine (red) il check gearbox for makers plate in morn, does have ford front axle though
As the title suggests , I've a matbro bray telestar 2524 that's started not wanting to go forwards, reversing for a while then changing direction helps, oil levels seem clean and fine but problem getting worse. It's my fault for threatening to change the old girl, any ideas on what to investigate?
Was a savage bus power wise when spooled up, bit lacking in comfort but not a bad bus if the figures stacked up, just to let others know there'll not be many that cost things out and weigh things up with an open a mind as eulb
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.