How well are they made?
I found them online but have not seen them in the flesh. I'd be looking at a basic telehandler mounted machine with rock spike and side tilt.
I'm also looking at Protech 220+ with heavier weight and manual tilt.
Any thoughts?
I'm treating some barley with propionic acid. Does the barley need sheeting? I've never tried this before. Plan to spray over a bucket load tip out and mix, then start again...
Does anyone know of a Youtube user guide for this monitor. I've been busy making a mount for the tractor half the day and although I've read the section in the user manual on the Signus, I can't quite figure it out yet...
I drove my loadall into deep water today to move a fallen bough from the river.
The water engine revs went up all the way and so I have parked it up to dry out.
I presume the throttle is fly by wire and that I’ve managed to cause a short circuit. Anyone come across this before?
2007 JCB...
So I’m looking to buy a used 750a and would like some advice on what wears.
I understand that the disc will wear down to 17” and then need replacing.
Seed boots have been mentioned on here as being a wearing part.
I guess I’m asking the question; If I buy a worn out 750a, what parts will...
I have a stock bull who injured his front leg last winter. His front leg repaired well and although he has lots of scar tissue around the knee joint, all is healed. However, he now stands more heavily on the opposite hind leg and rests the other hind leg in front of the other. Can anyone...
I'm looking for a fresh tractor. I'll be using for spraying, fertilising and pulling 4m direct tine drill with a hopper out front. So a reliable light weight machine, which is still man enough for draught work. Any ideas?? I'm pretty open minded on age, hours etc..
I'm looking for a fresh tractor. I'll be using for spraying, fertilising and pulling 4m direct tine drill with a hopper out front. So a reliable light weight machine, which is still man enough for draught work. Any ideas?? I'm pretty open minded on age, hours etc..
I'm looking at erecting a new set of farm buildings on our farm. It will need to include housing for 60 spring calving 650kg suckler cows. Bulls to be finished inside adlib at 13months. Heifers either kept/sold for breeding or finished by about 22months. Individual housing for 2 stock bulls...
I’m trying to work out how to remove the cab top. I have removed the three 5mm hex bolts from each side of the cab. Where next? Roof hatch? Does the cab top hinge up?
We have had a Catfire boiler since 2014 and we are happy with its ability to heat the farmhouse and neighbouring cottage, but I have been pretty hacked off with the fact that my installer hasn't wanted to connect it to the internet so that we can monitor it remotely. I have had several...
We have hundreds of old car tyres stacked up in the dry gathering dust. We no longer make pit silage and besides some of the tyres now have wire pocking through the side walls and are unsuitable. Does anyone have any ideas as to how I can dispose of them?
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.