Search results

What is a sensible sized grain bucket for a 3.5t lift Manitou? My current bucket will hold about 1800kgs of wheat and I want to go bigger without going too big for the machine.

How easy is it to remove the screen on the armrest on my Fendt 720 ? Its jumping between pages byitself so i am going to send it to David King Electronics. There are 2 allen head screws behind it but these are just turning without actually screwing out.

RAL 3330 is MF super red.

They sold them as a New Holland as well. I have a 4.5 tonne model.

Cable Tech will make you new ones if you send them an old one as a pattern. Simple enough job but may take a week or two.

Thanks for the replies. I will try and drive a vario model sometime before i decide.

I may change my Manitou next year and the dealer is pushing me to have what he calls the Vario transmission. I'm guessing this is a Hydrostatic transmission. Does anyone have any info on this gearbox? I have driven Claas and Merlo hydro telehandlers and cannot get away with either, i much...

Chart says 2 I think but it's not very clear. Theres another column on the chart that says 30, I'm not sure what that refers to ?

New to me Vad 400S with radar metering. What number do i set the manual screw scale at bottom of hooper on for drilling rape ? The book chart is a bit confusing.

Belt drive from land wheel and chain to the 2 cassettes. Not sure what the cassettes are other than they work fine for avadex

Horstine

Horstine, I think.

I forget the name of it. Its a fixed rate machine, so I guess the only way of altering rate would be different feed rollers or changing drive sprocket sizes.

Not sure where to post this, is it possible to get feed rollers to broadcast rapeseed with an old Avadex spreader ? Not panicing yet but just thinking of options if it stays wet.

Bidding on your 500.

Lemken will probably do as good a job as a Vaderstad but be cheaper to buy second hand. Vaderstad has very good used value.

How do i get the drum belt off a TX36 combine please. I am aware of the big spring behind the cover on the drum pulley but i'm not sure how to release the pressure off it.

Manitous dont keep time properly either, maybe its French thing ?

I used to gave a merc engined 735. I was perfectly happy with the engine. I was told the sluggish starting was because they Inadvertently came fitted a 24 volt starter. Not sure how true that was. Very happy with my Deutz engined one now also.

I have put a gauge on and pressure looks fine. Around 50psi all the time. I then swapped pressure switches with my 741 Manitou and it is fine.