Search results

Hi Lads. I’m getting error T124 on my 6475, it happens when hot in 4th gear. When tractor cools and I plug in and out the 4 sensors it seems fine but how do I know if it’s a sensor or a solenoid. Also where are the solenoids located. could I sw round the 4th range switch and solenoid ? Is this...

Hi. I have a problem with my rp235 net. On automatic is was netting but would not cut, just took net kni triggered, then I changed to manual tying and it worked fine for 20 or so bales but the started the same craic, it also started to net and the bale not even have made, I’m not sure we’re to look

are those the plates above the auger ? If so I have adjusted them down as close to the auger as I can

It’s seems to get caught on the end off the small auger between it and the rottor

Hi. I’m have trouble with my welger rp235 profi. i have trouble picking up 20ft rows. Was out this eventing lifting 20ft of light enough grass. Now the grass was damp but it clogged a good few times on me. Had to drive very very slow. Any ideas

Hi. I’m have trouble with my welger rp235 profi. i have trouble picking up 20ft rows. Was out this eventing lifting 20ft of light enough grass. Now the grass was damp but it clogged a good few times on me. Had to drive very very slow. Any ideas

Is there anywhere to buy wrapper belts at not crazy money

They have been replaced. And it was calibrated twice and got 1 new door sensor. I think the old sensor was ok too

Hi, hopefully somebody can help me so I’m a year on and still have issues. so last year I got the lely dearer out to replace door bushings and calibrate sensors at the end off the year, he was having problems trying to set 1 sensor voltage, so with no pressure on the door 1 sensor was 1.84v...

There’s not much off a noise from the door hooks

How can you adjust the time on the table

Hi. What do you mean by up the time ? And also the oil flow

Hi all. Just took the wrapper out yesterday, I’ve noticed in automatic mode after tipping the bale off the roller bed doesn’t come fully down, stays up 4 or 5”. I have to drop it everytime with the remote. any help appreciated

Hi, so I’m a year on and still have issues. so last year I got the lely dearer out to replace door bushings and calibrate sensors at the end off the year, he was having problems trying to set 1 sensor voltage, so with no pressure on the door 1 sensor was 1.84v and the other 1.16, and when...

Hi, so I’m a year on and still have issues With my new to me rp235 so last year I got the lely dearer out to replace door bushings and calibrate sensors at the end off the year, he was having problems trying to set 1 sensor voltage, so with no pressure on the door 1 sensor was 1.84v and the...

Hi. It was mowed dry and was around 22* both days, definitely was dry going into the bale

I make 700 bales per year. I have the tractors, mower and the time so saves paying a contractor 5k per year