Search results

https://sellmylivestock.com/view/listing/pedigree-hereford-breeding-young-bull-46690411

Have you had the steering system pressure tested? Initially ours was turned down as thought that was the cause.

I’d say hydraulic pumps just had very similar.

What year? They code will mean something to the dealer. Unfortunately I don’t have them codes.

yes I’ve got a good amount as well.

great I’m down in Pembrokeshire so I’ll get in touch with them. Thanks.

sorry for sounding thick but it’s all new to me, the salesman asked the previous owner who said it is liquid draw off gas but I can’t find much on google like that.

who do you rent yours from?

Thanks, So is it propane or lpg?

Ok so I’m looking at buying a grain drier, it’s gas and prob best value for me at the moment. Question is what gas does it run off where do you get the gas and roughly how much would it use to drop 12 ton 4% moisture. Thanks in advance.

Any error codes? could be BOC clutch switch. Calibration warm transmission a bit, 1500 revs on flat concrete, aircon off handbrake on lift shuttle straight up whilst holding down 4WD button once you get transmission temp show up on pillar screen place into forward until you get flashing N...

Any one fairly clued up on these? Wanting advice on auto gearbox repair. when we start it it run drive briefly then cuts out, start stop and away u can go again but briefly. I’ve been told it might be torque converter? And I’ll need new torque converter and auto gearbox, but do I or do Ijust...

The 4wd button. On corner pillar it’ll flash and you’ll get transmission temp put into forward leave there until a flashing N then turn off for 30 seconds to save the calibration, it will only calibrate with transmission temp between 35 and 45 I think. I also thought it was handbrake on and air...

I bought 22 lengths of 5 inch snaptite I very the last 2 years so got very good at putting storz I n, I found if u cut a sleeve off the end of the pipe it would get bigger, huge variation in hoses, some were slack some tight. But after cutting a bit off most were slack enough.

what size pipe you using and what you spreading with?

Hi I have one of these for my loader and use it on front linkage for buckraking as well. Seems the joystick went dead the other day no lights on it. They say the joystick is caput, anyone knows of cheaper sources of replacement or maybe an electronic joystick and spook block as the asking price...

assume threaded holes in impeller are worn and you can’t use them to push it off. It impeller is just on shaft with key and should come off after but taken off, what I do is go around front of pump, and wind the 2 17 mm bolt heads out equally, to push housing forward and in turn pushes impeller...

Hi I’ve got engine oil in my air tank, assume it’s the piston ring worn on the compressor, has anyone rebuilt them? Where could I source parts? Thanks in advance.

You can do it yourself.

Has gearbox been calibrated recently? Usually gearboxes are good if calibrated.