Search results

Anyone got one not being used anymore before I buy a new one, thanks

Disc Mower: Krone - Category: Disc Mower Manufacturer: Krone Price: £2000 Condition: Used Description: Krone 8 foot cut plain mower, off small farm, done 60 acres a year from new in 2001. Barn stored. £2000 Ono Selling for a friend Images: See the full size images for this listing on...

Need to concrete a silage pit floor, the back wall is a long way below finished concrete level as it was filled in to bring the level up, the stanchions have been made with hoops on to catch ''U' shaped rebar which will then tie into the mesh as we concrete, so the whole floor is tied into the...

Any body know how to change the operation of knocking the joystick across and pressing the little black button on the side of the console for floating the front services on a sidewinder armrest? Would prefer to operate the front linkage like that and have the services on back and forth where it...

Just ordering concrete panels to fit 20 foot bays for a silage clamp, what thickness panels should be used? Panel height is 3.6 metres and it's indoor so can't go any higher. Thanks

Had 4 cows out of 40 pd positive served in october come bulling again December/January, 4 bulls used in total but the 4 cows that have reabsorbed were all by one sire? Coincidence? Typically all sexed :banghead:

Just doing a couple of new silage pit floors and contemplating using asphalt although we have no issue with current concrete floors as far as effluent eating in to it goes. What depth does the asphalt need to be? I presume a very solid hardcore base is fine?

I'm after the additional lower engine panels that were mainly fitted to the series 3 if anyone knows where there may be some lieing around. Thanks

After a decent 10-16ton tipping trailer with hydraulic back door, anything considered Thanks

looking for a post knocker if anyone knows of one anywhere, preferably a wrag/protech/bryce with a rock spike. Thanks in advance

Anybody ever had problems with floor slats bending on a giga forage wagon? Had a couple bend slightly over the years and just taken them off and put them in the press and straightened them and put them back on, but had one yesterday that ended in an unrepairable state as it got spat out as the...

Anybody know where I could find complete discs and hubs for mounting in front of some old aitchinson spring arms/t boots for direct drilling into grassland? I found some on Spalding's website but they were £300+ per unit [emoji33]

Is there any advantage to using a grassland subsoiler over one of these aerator rollers like the alstrong/aerworx when only dealing with compacted shallow soils on top of clay? Both the aerworx and alstrong unit claim to deal with compaction down to 6-7 inches, any further than that here and...

Grassland subsoiler, fairly simple really which one does the best job? It's only doing our own work so doesn't need to be over made as if it was going out on hire or contracting.....

Anyone seen one of these in use compared to the traditional type weighted post knocker? Are they any good or do they wreck the posts?

Anybody had any experience with this company, look to do some very good kit on the website and just wondered if anyone had dealt with them on here?

Any body had experience of these feeders? Look like a nice idea, not had a price yet but wondered if anyone had seen them in use

Considering a new parlour at the minute, we are planning our system around 1 man and occasionally 1.5, currently have a 10/20 and can't imagine being able to handle a 20/40 during in winter with a proper pre wipe and post spray routine, most reps are recommending a 16/32. Spec wise it would have...

What size steel would I need for an outdoor pit? 12ft walls, so how much would I have to put underground?

Looking for a cocker spaniel puppy. Message me if anyone has anything of interest