Search results

OK, I didn't want to hijack the forum with advertising a bit of Hay.

Midi Heston Hay bales. I was hoping it wasn't Facebook, I'm really crap on it!

Ah, maybe not too much to be learnt from that then! Well perhaps that barley drowns like any other crop but I think we already knew that...

@Two Tone How does the barley look? What did you do in the end?

As title suggests, I am just wondering where people advertise forage for best results? TIA

What do you mean by 'wonder where that model will end'? Like all the others, trimble etc, maybe?

Just wondering how people are getting on with these systems? TIA

Has this combine been shelved? Don't here anymore about it?

Hi, We have been trying to cut our winter beans with our 570 lexion and they keep wrapping around the rotor bearings. We started last Wednesday and did about 15 acres before the bearings burnt! Replaced bearings and waited until yesterday to have another go. Same issue only I checked them...

Right here goes... My AGCO (topcon) Agi-4 dome on my MF tractor has died (according to dealer) so I need to replace it but a new one is £6500:mad:. Can I use a topcon Agi-4 instead and just move the snap in modules across? I have been advised that this will work by another dealer but I thought...

Thanks, I will give them a call

Hi, I am looking for a someone to mill and mix for me. Does anyone know who does this in the south east? We are on the East Sussex/kent boarder. TIA

Hi, I am looking for a someone to mill and mix for me. Does anyone know who does this in the south east? We are on the East Sussex/kent boarder. TIA

Have you gone for another gd or something else?

What's the reason for sale if you don't mind me asking?

Does anyone know where I can get a ram seal kit for a simba xpress? One of the wing rams internal seals has given up. Tia

Thanks , do you know where the 12v switch signal needs to inputted?

You all sound quite clued on the C3000/x30 screen. Is there a way to get the work trigger to be switched from the tractor? I don't currently have a work trigger I just leave it painting but it would be useful if it would come on and off as required. Also if there is a way what cables etc...

I was also told that when planting grass seed it can blow out of that hole if you don't use the reducing ring that fits on to the elbow pipe on the bottom. Something to do with the grass seed being so light. I appreciate your not planting grass but it might help diagnose the problem

We were advised by Mike on set up day to calibrate it so that your max speed was around 18kph. This keeps a happy compromise between 'spooning' and the motor going too quickly. I'm not to sure about the book, the fan speed it recommends for a 6m irc is 5000 but if you run ours more than 4500 it...