Hi all
These last few weeks i've been learning allot of the canbus of Fendt. I've managed to control all hydraulic valves trough
the canbus. Now i wonder this :
If my tractor has section control active, is it possible to get this information over canbus , so that i can create a controller
that...
Hi all.
I own a 718 SCR , with the standard spool valves on the back of the tractor. I know that fendt sells tractors that have spool valves
with a lever to be able to connect the hoses even under pressure.
I thought it would be very handy to have 4 buttons on the back that i can use to set...
Hi all,
our 526 Turbo died last week, it had done it's fair share of work so i'm really not complaining.
We are in for a replacement and the dealer has a 635 130 PS+ on stock, but i'm bothered with the width , it's
almost 2.4m wide (i'm metric, sorry) and mine was 2.15m. The difference is...
Hi all !
I own a 526 and since a few weeks i've encountered following problems:
- flaslights do not work, not left, not right.
- shortly after this problem all the warning indicator lamps and the audio alarm went down. none of them light up when i turn the ignition on.
I've checked every fuse...
Hi all,
i bought a second hand ezguide 250 , who works good enough for me for spraying. But i wanted to add a work switch to it , so i can see
where i have been spraying or not. But i can't seem to get it working. This is what i've done so far :
- updated the device to the latest software...
Hi all,
i have a EL-3 spray computer that acts a little weird. When i flip it on , it seems like it's getting no power, but after a while the screen and the LED's
all become brighter and the unit then works, but that can tak up to half on hour. I wanted to see of the 12v power supply comes into...
Hi all!
In my days, next to farming, i have been busy with microcontrollers (professionally and as a hobby) , and i have alway been interested in building
my own circuit board so i can convert non-isobus machines to isobus.
It seems that there is not allot of info about this, there are...
Hi all,
i own a Fendt 718 SCR which came wit a built in Topcon AGI-4 GPS , on EGNOS . I've wanted to upgrade it to RTK and i found a radio module
that i bought. Now when i opened the reciever, i noted that the IMU (the gyro module) was not installed , even do i have gyro readings on my...
Hi All,
for 2 years i have been working with a Topcon AGI4 reciever in our Fendt. It works with Egnos correction signal (no RTK) and i always had a pretty
good accuracy (20cm) , enough for what i use it for;
Last few days i'm unable to connect to Egnos, Signal is only one red bar and no fix. I...
Hi All,
i recently wanted to add 2 speakers to my fendt tractor, since it has 4 places to install speakers.
There are 2 installed in the back, but none in the front. When i removed the plastic that covers the
speakers, i didn't find any place to install the speakers onto. On the back, there is...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.