Search results

What was the issue with it not working?

I use Orbseal, but have used Noroseal in the past and found it quite good also. The most expensive product isn't always the best either.

Lovely, what area are you farming in? Grazing is a long way off with us.

We run a Manitou MLA 533 also, it came new late 2020, it's been a very capable loader, a pleasure to use and much better on the clamp than I was led me to believe when researching loaders. It needed a sensor on the headstock, and one for the transmission under warranty and Manitou backup has...

We have one, wouldn't be hard to talk to I'd your interested. It's been sat out for a few years but it was inaccurate prior to that and still not bad.

What could you lift per hour in between breakages?

What was usually breaking? Maybe gear less and give it a chance could have been better for output :p

Very nice! what sort of output could you get out of that setup?

1060 & 1260 share the same drum and feed rollers 1360 & 1460 have the same width drum as the 1100

Nightmare!! Tedders are bad enough, but a bad man on a tedder is even worse!! 🙈

I don't think any machine likes lifting those sorts of swaths 🙈

Absolutely this!! (y)

How long did you feed toxin binder? I always feed it at a low rate as an insurance policy, if I thought there was a risk for whatever reason i increase the rate.

Enjoyed that video, looks a fantastic setup, well on top of their game (y)

I missed your post where you adjusted it, grand job if it worked.

Are you sure there is actually a problem and not that with the colder weather there is less demand on the fans? I wouldn't be a 'fan' of controlling the speed of only one fan, much prefer both fans being speed controlled, gives much better control of your liquid line pressure and prevents over...

Wanted Mk2 JF 1100 or 1050 Ready for grass or needing repairs. Would also consider a 1350/1355

Why not get four and milk all the cows? If it didn't pay to get four it would hardly pay to get two 🤷‍♂️

Q-Bed (y)

In my mind for your cow numbers 36 or 40 point Rotary, full spec, with separation gate. Get the milking done in little over an hour The parlour would be about the price of two robots and the shed to put it in would be about the price of one?