Hi .
With my axis 30.1 with electronic metering I have to set up the spreader with the app to get the spread pattern and then weigh the quantity of fertiliser that falls into the calibration bucket over a set time.
In put that information into the computer and that then sets the spreader flow...
Hi everyone.
I've got a kuhn axis 30.1 with s4 discs on 24 meter tramlines and need to spread some Origin 26.0.0 35. Has anyone got a setting for me as its not on the kuhn app.
Thanks
Hi all.
I'm thinking about going down the auto steer route on my Case Puma. Is RTK Range point good enough for drilling. I don't want to end up with gaps and overlaps. I can do that on my own. Thanks in advance.
On our TX63 the 3 electro hydraulic valves that engage the Separator, header and unloading spout have started to stick when engaging the switch. Once freed off the valve is ok untill the next day when the same happens. Any ideas?
I've just tried it and it works. I had SBAS turn on. Whatever that is. Turned that off, rebooted and it all works fine. Anything else I should do. Thanks again.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.